I have a 2004 rodeo. When I apply the braks I slow down but then at a certain point they slipp and I don't really come to a stop. Today the abs light came on. What could the problem be? I have ample brake fluid.. Please help

I had the same thing here, I paid lots of money to find out what is the problem, mechanics played with my poor car damaged everything they can to stop it from running, but when I found out that when I changed the battery on my own, with a turkish manufactured battery of 100 A big battery, not even the fault stopped appearing but all the car was boosted in performance, Dsc not available and Park Brake is all related to the level of electricity running the parts of car was screaming back to you, change my battery, all parts of Jaguar runs on electricity, main computer now runs faster, no delay on screen, and now Dsc not available once ignited doesn't appear anymore, remember that once car is reset by battery change, you need to apply brake and boot (step on brak and hold park brak lever up at the same time with pressing computer button on stearing whisk for like 10 sec until you see on screen AVE back again), and bypass radio lock by pressing on the three buttons, mem and the right combination with >>, and you're set

could be the ABS sensor contacting the slotted sensor ring. just behind brake backing plate.

SOUND LIKE PROBLEM IN THE ABS BRAKE SYSTEM AND TRAC SYSTEM.TAKE VECHICLE TO DEALERSHIP.THEY HAVE TO USE A TECH SCANNER TO TROUBLE SHOOT AND FIX PROBLEM.

Your ABS sensor/s... you have to check them all...Sometimes the sensor outer wire gets worn,an the wires are exposed on the inside, now if this has happened...the wires will short out, when they touch the metal frame of the vehicle, which will cause the vehicle to cut off... However also make sure you dont have any vacuum leaks from your brake booster... A big loss in vacuum will also have the vehicle to loss power....Gooduck...

Is there an ABS or traction control warning light on? A malfunction in these sytems could cause the problem you describe.

usually when it is pulsating in brake pedal, it is the front rotors that are warped. replace front rotors. the abs light does not have anything to do with reguler brakes. if abs is bad brakes will work ok.

bad earth somewhere

i'm not entirely sure on this but it sounds like the assist is not working, i think it works with the power steering , so check htat level, and the belts, i hope this helps

have car scanned auto zone -advanced auto and some other auto stores will do this for free most likely one of your sensors is starting to go bad usually will activate at low speed under 10 mph as ur slowing down do check this problem early as abs can cause vehicle to stop longer

your master cylinder is gone. when stopped apply pedal and hold let up slightly then reapply if pedal sinks to floor master is bad.