HOW TO REMOVE THE POSTIVE TERMINAL FROM THE BATTERY ON A 2002 HYUNDAI ELANTRA

Replace left front fender - Fixya

www.fixya.com/cars/t26028082-replace_left_front_fender

Dec 29, 2015 - replace left front fender - Hyundai Motor 2003 Elantra question. ...Question about Hyundai Motor 2003 Elantra. Open Question ... How do i remove left front fender clip on a Lincoln ls 2002? Jan 04, 2015 ' 2002 Lincoln LS.

Replace 2003 hyundai elantra front passenger outside door ...

www.fixya.com/cars/t17348691-replace_2003_hyundai_elantra_front

Mar 26, 2013 - Question about Hyundai Motor 2003 Elantra. Open Question.Replace 2003 hyundai elantra front passenger outside door handle. Need to replacebroken exterior door handle on front passenger .... replace left front fender.

remove the interior door trim and you will see small nuts holding the handle onto the outer door skin. Remove any rods /clips and undo the nuts and the handle will come out.

sound like the alter belt or the alternotor itself needs to be replace to go the cheap way first i would have my battery tested and to check the alter yourself do this easy test start the car with the car running remove the postive battery cable off the battery if the car stay running then the altern is good if it shut down you need a new alter good luck

From www.hmaservice.com

REMOVAL 1. Remove the rear seat cushion. 2. To reduce the internal pressure of the fuel lines and hoses, first start the engine and then disconnect the electrical fuel pump connector. Be sure to reduce the fuel pressure before disconnecting the fuel main pipe and hose otherwise fuel will spill out.

3. Disconnect the battery cable from the negative terminal of the battery. 4. Remove the high pressure hose and fuel return hose. 5. Remove the fuel pump assembly

if your battery died or you replaced battery, disconnect the postive terminal from battery. insert key into igniation to on position (not start) then reconnect the battery postive terminal.

Normally the Audio (Radio CODE) is noted in the owner's manual. If you don't have it, you must contact Hyundai Motor America and give them the Vehicle VIN number... they may then (possibly) be able to give you the CODE.

Two retainers hold wheel well liner at the bumper - remove them then bend liner back to access marker lamp assy & socket.

To Remove:

1. Disconnect the battery ground cable.
2. Remove the speedometer cable and the shift cable.
3. Disconnect the starter motor connector and terminal.
4. Remove the starter motor assembly.

To Install:

1. Install the starter motor assembly.
2. Connect the starter motor connector and terminal.
3. Install the speedometer cable and the shift cable.
4. Connect the battery ground cable.

1. Disconnect the negative (-) battery terminal. 2. Remove the front side cover screw. 3. Remove the front fog lamp assembly connector (A).

4. Remove the front fog lamp bulb (A).

1. Disconnect the negative (-) battery terminal. 2. Remove the nuts holding the rear combination lamp. 3. Disconnect the connector and remove the lamp assembly.

It is located in the trunk, behind the furthest rearward panel. (right inboard of the light housing).