How do you install a front wheel bearing on a 2001 Pontiac Montana
Jack the vehicle up remove the wheel
remove the brake caliper bottom bolt 15mm. lift the caliper up and slide the caliper pin out
remove the caliper housing bracket 2 - 15mm. bolts
remove the brake rotor
remove the drive axle nut 1 5/16
the remove the hub bearing bolts 3- 13mm. they are in behind (best to use a 13mm flex socket)
disconnect the ABS harness
use a hammer and hit the hub bearing flage (it maybe corroded )
now the hub bearing is out clean the steering knuckle with sandpaper to remove corrosion
install the hub bearing (make sure the ABS harness is in the right position)
and reassemble
hope this helps
Testimonial: "Thanks for the very useful information. That was all I needed to get the job done."
655 views
Usually answered in minutes!
×