Help my Mazdas clutch pedal is stuck to the floor.
It was sitting for about a month when I tried to start it I pushed in the clutch but it never came back out??
It is most likely a hydraulic clutch, and it is most likely leaking at the clutch slave cylinder. Check the clutch master cylinder for fluid, it should be a small master cylinder looking thing with a fill cap next to the brake master cylinder and booster unit. If it is empty fill it with the same dot 3 brake fluid that you use for your brake master cylinder, and make sure that you are pouring the fluid into the clutch master cylinder reservoir and not the rubber seal that should be under the fill cap. After filling the clutch master cylinder up with fluid, then try and pump up the clutch pedal. It might take a while to pump up hydraulic pressure, and you might also have to work the pedal a few times by hand at first.
Also, you might have to bleed the clutch at the slave cylinder if it will not build up enough pressure to release the clutch.
Check to see if you have fluid first
if it does then pull on your clutch pedal and pump it for a while until you have pressure or have someone help you bleed the clutch slave
2,962 views
Usually answered in minutes!
peedle stuck to floor
×