Is there a reset button for the fuel pump in a 2000 Jeep Wrangler?

Check fuses first, but could be needs new CPU

The in tank fuel pumps on these vehicles have check valves to hold fuel pressure. possible bad fuel pump check valve, Try turning the key to the on position three or four times to let fuel pressure build up and then see if it starts easier

Check your relays. Find where you've got power and where it stops... you'll find the problem. Good Luck. "It's always something simple."

check foe fuel pump presure at fuel rail,,,if u have fuel pump presure check all fuses with a test light not buy sight,,could be deceviving ,look at and check to see if fuel pump relay is working if no fuel presure i,if u have presure in fuel rail ,replace the cranck shaft sensor

No, the ignition coil has nothing to do with fuel pump.

doesnt sound like the fuel pump!!
more like a bad body ground!!!!!!1

Check all your fuses make sure their good. Your fuel filter should be changed once a year. Or in worst case it might be your fuel pump. If it was a rough road it might have set off your emergency fuel shut off system. Check your owners manuel to find the lacation and reset button.

First, re-check your repair to make sure it has not come apart. Check to see if the pump is running and pump relay is working. I'm pretty sure that your filter is incorperated into the fuel pressure regulator on top of the pump assembly..If the filter is not on the frame rail near the left rear wheel, that's where you will find it.check that you have proper flow and pressure. Your problem sounds like a possible plugged filter.
Don't forget that aside from fuel, you need spark as well. Make a quick check there to make sure you're not looking for the wrong problem. An easy way to check is to squirt carb cleaner into the throttle body while cranking. If engine starts, problem is on the fuel side.

There is a fuel pump relay in the fuse box under the hood. See if it is clicking when you turn on the key. If not you may still have a blown fuse.

check your fuel pump relay and your ignition switch those numbers you gave for voltage are not right, please recheck that you have a ground and 12volts at the pump while cranking please rate -jeff