At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Pull the plug off the wheel bearing. Turn the key on and check for 5 volts at the plug. No voltage, the wire usually breaks close to the plug. Check the plug with an ohm meter. At the plug and about six inches back. Ohms OL, repair the wire. Power at the plug, you bought a bad wheel bearing. The sensor is built in.
Probably a starter. It sounds like the starter solenoid is working, but the starter motor is not energizing.
You could try this simple trick, but Im about 85% sure you have a bad starter.
Have a buddy help you push the vehicle in neutral for a short distance. When you get it moving at a walking pace, put the transmission in Drive, and let the vehicle come to a stop. You may hear a little clicking, but thats OK, it wont hurt anything. Put the transmission back in Park and try to start the engine again. Sometimes the starter gear gets stuck on the flywheel and it wont engage when you try to start the engine. This trick may move the flywheel a little so the starter can engage.
when was the last time you put in fuel injector cleaner? I put in Lucas Oil Injector cleaner every other or every oil change.
There are alot of factors affecting your gas mileage. Tire wear, tire pressure, wheel alignment, air filter, fuel filter, spark plugs, oxygen sensors, just to name a few. So to say what you need is just shooting in the dark without more information. I would probably start with your oxygen sensors, and then perform a tuneup. If your vehicle pulls to one side or the other when driving on the highway you need to stop into the shop for a wheel alignment.
NEEDS AN OIL CHANGE. YOU CAN RESET IT YOUR SELF. HOLD IN THE "TRIP" BUTTON AND TURN THE KEY ON (DO NOT START IT) 5 DASHES APPEAR AND DISAPPEAR 1 AT A TIME THEN 5 "0"'S AND YOUR DONE. SOMETIMES THEY HAVE TO BE ON "TRIP A" BEFORE YOU START
the drain plug is located on the back of oil pan in the center. if you have a rock guard you have to remove this first. the pcv valve(positive crankcase vent is located on either the left valve cover in front or on theif it's a v6 or 8 or it is located on the valve cover in the back in a straight six it will have a hose that goes to your air filter breather box or the breather hose. please rate this...........thanks
×