SOURCE: continous clicking (signal lights)
The multi-function (aka combination) switch probably has contaminated grease in the switch contacts from wear.
See:
http://www.wikihow.com/Fix-Grand-Am-Turn-Signals
for do-it-yourself repair instructions. You can also buy a new
aftermarket switch, if you don't want to take apart the existing one
and clean up the electrical contacts.
For example, see:
http://www.autozone.com/Ntt,SW1414/shopping/allResults.htm
(or just go to http://www.autozone.com/ and search for part #SW1414)
For 2003 Grand Am, it was listed as "Duralast / dimmer switch", but other makes & models may go by another name.
Another link:
http://www.1aauto.com/1A/HeadlightSwitch/Pontiac/GrandAm/1AZCC00031/703400
The OEM (GM) part number for mine was: 22676853
SOURCE: Flasher clicks turn signals all work. What needs
The clicking noise is you concern ? I would replace the turnsignal switch or the hazzard switch.
Good Luck
SOURCE: I have 2001 grand am se and each time I use the
you will need tho change the signal switch in the steering column.
to replace it you will need a flathead screw driver, and a 7 mm socket and driver.
first you pop off the top cover of the steering column, there are no screws holding this just use screw driver and feed it into where the signal arm goes in and pry up
now use the 7 mm to remove the two bolts holding switch assembly in place.
pull up on switch and unplug the three connector on the back of switch.
plug in the new switch and then line up the switch back into place.
NOTE THE HORN SPRING WILL CAUSE DAMAGE IF YOU DO NOT PUSH IT IN OROUND THE COPPER DISC IN THE STEERING PLATE. just look at the old switch before removing it to see how it goes back in. (this is usually what people forget about)
replace the two bolts and cover.
you will now have no more clicky noises.
SOURCE: indicator signal clicker is constantly clicking
Please let me know if I understand you correctly, your blinker signal relay is constantly going....blinka
blinka blinka blinka blinka ?, BUT you DO NOT have the blinkers on ?
Please let me know
TAIL LIGHT NOT WORKING
It
can be faulty tail light bulb or its issue with tail light control
switch or its wiring's are short.
Check the voltage at fuse slot of tail light.Do you receive 12 volt
there.If not,then it says tail light switch is not receiving power supply.
---------
There
are few help links related to your problem.I suggest you refer the list and
check the help links.Click the link below:-----
----------
http://schematicsdiagram.blogspot.com/2011/12/right-turn-signal-not-working-on.html
--------
http://schematicsdiagram.blogspot.com/2011/12/only-one-side-indicator-light-working.html
-----------
http://schematicsdiagram.blogspot.com/2011/12/turn-signals-not-working-on-1987-jeep.html
-----------
SOLVE YOUR 4 WAY FLASHER RELATED PROBLEMS HERE
http://repairhelpcenter.blogspot.com/2012/11/4-way-flasherturn-signal-flashersignal.html
----------
http://whatisbyme.blogspot.in/2012/04/1994-toyota-camry-bypass-tail-light.html
-----------
--------
---------
----------
http://schematicsdiagram.blogspot.com/2011/12/car-tail-lights-not-working.html
----------
These details will help.
Thanks.
267 views
Usually answered in minutes!
×