I am looking for a wiring diagram for a 2001 Ford Explorer for the automatic side view mirrors? The fuse is good, but neither the left or right side mirror will operate. I am guessing it may be the switch, but would like the wiring diagram

Ford Explorer (1996-2001) fuses and relays

https://fuse-box.info > ford > ford-explorer-1996-2001...
Fuse box diagram (location and assignment of electrical fuses and relays) for Ford Explorer (1996, 1997, 1998, 1999, 2000, 2001).

1997 Ford Explorer fuse box diagram - StartMyCar

https://www.startmycar.com > Explorer > Fuse box
The 1997 Ford Explorer has 2 different fuse boxes: ... Ford Explorer fuse box diagrams change across years, pick the right year of your vehicle: 1996, 1997 ...

1995-2003 Ford Explorer Fuse Box Diagram

https://knigaproavto.ru > shemy > 314-explorer-fuse
Jul 29, 2017 - Fuse Box Diagram Ford Explorer and Ford Explorer Sport - 4.0L ... Small Block (XL, XLT, XLS, Eddie Bauer & Limited; 1995, 1996, 1997, 1998, ...

Ford Explorer (1995 - 2001) - fuse box diagram (USA ...

https://www.autogenius.info > ford-explorer-1995-200...
Aug 7, 2015 - Ford Explorer (1995 - 2001) - fuse box diagram (USA version). Year of production: 1995, 1996, 1997, 1998, 1999, 2000, 2001

Fuse Box Diagram Toyota Sequoia (2001-2007)

https://fuse-box.info > toyota > toyota-sequoia-2001-20...

2001, 2002 - The fuse box is located in the left side of the instrument panel, behind the cover. The location of the fuses in the passenger compartment: ...

Toyota Sequoia (2001 - 2002) - fuse box diagram - Auto Genius

https://www.autogenius.info > toyota-sequoia-2001-200...

Aug. 21, 2016 - Toyota Sequoia (2001 - 2002) - fuse box diagram · Engine compartment · Instrument panel · Fuses (type A) · Fuses (type B) · Fuses (type C) ...

F5 5 Rear window motor. Roof opening panel module. Auto-dimming interior mirror unit. Door lock switch, driver side. Door lock switch passenger side. Power window motor, driver side front. Overhead console switch assembly
Not sure if this is what you're looking for. Let me know if it works.

did you check power mirror fuse? if ok, remove your power mirror switch at the driver side and clean the contact area, take a test light and check all wires for good connection. one by one test the voltage output,-/+ by pressing the switch, if all wires have output -/+ , and mirrors still not working, remove the switch connector, find out the three wires going to power mirror and direct it to - and positive voltage alternately, if the mirrors move, repair the wire that cut on the moving area, if still not moving repair or replace the two motors inside the mirror

go to the ford dealer or a salvage yard and but one. It's about 3 bolts and a wire plug.

B

Aside from the fuses, your drive side power door lock may be failing to work because of a bad door-lock relay system, or, alternatively, the locking switch/button, itself, is not malfunctioning and in need of replacement.

A great handyman site that specifies the above probable causes and more is the following link:
http://yourhandymanzone.com/Your_Handyman_Zone_How_To_Pages_Vehicle_Car_Zone_Cars_Trucks_Vans_Locks_Power_Locks_Do_Not_Lock_When_Pressing_Locking_Switch_Button.htm

Good luck!

Mirror — Outside Rear View Removal
NOTE: Do not remove the exterior mirror assembly when repairing an individual part. Individual components can be installed without removing the exterior mirror.

1. Disconnect the battery ground cable (14301).

1. Remove the front door trim panel; refer to Section 501-05.

1. Remove the speaker.
   1. Remove the screws.
   1. Disconnect the electrical connector.
   1. Remove the speaker.

1. Remove the outside rear view mirror (17682).
   1. Disconnect the power mirror wiring clips.
   1. Remove the outside rear view mirror nuts.
   1. Remove the outside rear view mirror.
      • Feed the power mirror wiring through the opening in the front door (20124).

Installation

1. NOTE: When the battery (10655) is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.
   To install, reverse the removal procedure.

are you trting to tighten the mirror glass or the mirror where it attaches to the body? I don't think glass is removable in 99. Only can try to press on glass to seat if unseated. not too hard.

1. Remove the front door trim panel; refer to Section 501-05 .
2. go to car-part.com for a used mirror. Page with * is cheapest seller.

1. Remove the speaker.
   1. Remove the screws.
   1. Disconnect the electrical connector.
   1. Remove the speaker.

1. Remove the outside rear view mirror (17682).
   1. Disconnect the power mirror wiring clips.
   1. Remove the outside rear view mirror nuts.
   1. Remove the outside rear view mirror.
      • Feed the power mirror wiring through the opening in the front door (20124).

------------------------------------------------------

----------------------------
SECTION 501-09: Rear View Mirrors 2001 Explorer/Mountaineer Workshop Manual
REMOVAL AND INSTALLATION Exterior Mirror Glass, 2001 model Removal
NOTE: Exterior mirror glass is serviceable only on vehicles built after July of 2001.
NOTE: Passenger side exterior mirror shown, driver side exterior mirror similar.
All mirrors

1. Position the glass in the full up position.

1. Locate the notch at the bottom of the exterior mirror glass.

1. Release the exterior mirror glass.
   1. Insert a long flat-bladed screwdriver in the notch.
   1. Push the screwdriver into the notch until the glass is released.

Heated mirrors

1. Position aside the exterior mirror glass.

1. Disconnect the electrical connectors.

All mirrors

1. Remove the exterior mirror glass (17K707) passenger side or (17T675) driver side.

Installation
Heated mirrors

1. Connect the electrical connectors.

All mirrors

1. Position the exterior mirror glass on the exterior mirror motor.

1. Place a hand against the back of the exterior mirror housing and a hand flat against the exterior mirror glass. Press the glass in place until fully seated.

http://www.genuineservice.com/genuineservice/en/default?page=genuineService

Go to this site pick owner guide from left task bar and get the owners manual. Your fuse info will start on page 162

I believe the fuse for your starter is in the power distribution box, 93 explorer 4.0L 4X4. find diagram for this in Chilton Ford Ranger/Explorer/Mountaineer 1991-1999 Repair Manual 26688 page 6-43 Fig.88 Be aware that there are (4) figures for the 93 4.0L explorer and each shows a different part of the same engine wiring. See top right 'power distribution box' follow lines to the part of your engine you are concerned with, which fuse number, then look inside your engine, passenger fender, push down on the protective ?wall then pull the cover up, see your diagram and fuse numbers. The diagram for inside fuse box, page 6-31 fig.63 I hope this helps