Does anyone know if the throttle postion sensor is adjustable on a 91 oldsmobile cutlass ciera? The chilton says some cars are, but doesn't say which cars. If so, how to adjust. Still having the same probs with dying, high idle and trying to cut out on highway. Checked the idle control, changed the pcv valve and now thinking maybe the throttle position sensor is bad. Thanks for any help.
Marilyn
I'm assuming you have the 3.3l v-6. When I look up the part, it seems to have slotted holes. Therefore, it is designed to be adjusted after installation. If your tps has these slotted bolt holes, adjust it to satisfy the settings in the test procedure below.
SOURCE: The windows in the 95 oldsmobile cutlass ciera won't work at all
maybe the wire is severed where the door (drver dr) pivots. thats what was wrong with mine. there is a rubber boot with crinkles in it that hold all the wires together. you can also try replacing the switch board that controls the wndws on the drvr dr. hope that helps.
SOURCE: 1991 oldsmobile cutlass Location of starter
Follow the red wire from the battery towards the firewall. It will end at the starter.
SOURCE: Changing spark plugs on a 1995 Oldsmobile Cutlass Ciera
ALL YOU NEED IS 3/8 RATCHET WITH A 5/8 SPARK PLUG SOCKET.YOU NEED EXTENSIONS AND UNIVERSAL JOINTS TO GET TO HARD TO REACH PLACES.YOU NEED A SPARK PLUG GAUGE.YOUR SPARK PLUG GAP SETTING WILL BE. 0.060 THAT WILL BE FOR THE 2.2 AND 3.1 ENGINES.
Testimonial: "Thank you very much for your advice and time!"
SOURCE: how do I remove the windshield wiper arm from a
most car parts stores will do it for you and you can watch
SOURCE: 1995 oldsmobile cutlass ciera wiring diagram
they can be bought on line but the easiest way is to buy a manual from local parts store, or possibly check one out of the local library
This 3.1 L back center of engine
The Crankshaft Position Sensor is mounted remotely on the bottom side of the ignition module.
721 views
Usually answered in minutes!
Yep, mine is adjustable. Never mind this question.
×