SOURCE: what transmission will fit in an 89 gmc sierra?
if it has a 4.3 liter motor a 86 to a 97 if it has a 350 motor a 81 to a 96 will work hope this helps
SOURCE: HAVE A 03 GMC SIERRA
I had the same problem in my wife's 2003 Yukon Denali. The power seats and passengers side window wouldn't work. Turned out to be a blown Buss Type fuse in the Underhood Fuse Block. It is the one marked MBEC 1 50amp. Hard to tell if the are blown so look very carefully. Should look like a hoop with two shiny solderlooking bubbles on either side. On my blown fuse, it caught my attention because it looked like the solder was missing and I had to look very closely to see the bottom of the "hoop" was open. They are very hard to remove and must be pulled straight up.
This type of fuse looks like a red square with a clear plastic top showing the fuse link under the plastic. On my vehicle it is on the top row second one from the left.
SOURCE: How to replace '96 Ford Explorer driver side exterior door handle
You will need to remove the door panel to gain access to the handle. Roll the window up or down as needed to get to the nuts that attach the handle to the door. You will also need to remove a rod the goes to the door lock. You will see the rod after the door panel is removed. Good luck.
SOURCE: Drivers Side Door Handle
You need to take inside door panel off This just clips on but there are screws in armrest and inside door handle look for any other small square covers that may hide screws Lift panel up Make sure window is up Disconnect wiring from panel and you can now get at door handle linkage and bolts
SOURCE: My 2004 GMC sierra blows hot air out the drivers
If you've replaced the actuators and they are working.
One of the blend doors may be broken inside the heater box. To repair or replace the broken door you
have to remove the heater box. This is not a small job. The book gives 6-7 hours for the job. There is a
cheat that I've heard good things about. I guess it can
be done in a fraction of the time. You can find out
about it at heatertreater.net I have not used it myself
but I know somone who has. And it worked well for
him. Hope this helps.
189 views
Usually answered in minutes!
×