I have a broken brake line above my gas tank and I can not find a diagram to show me if the line runs straight across the tank or if there are other connecting lines above the gas tank that I can not see. I have a 99 dodge grand caravan. Do you know if there are any other connecting lines that met above the tank of is it just a connecting line for the back tires only? Or where I might be able to find a diagram of this vehicle?

SOURCE: REMOTE KEYLESS ENTRY 99 GRAND CARAVAN

INSTALLATION: REMOVE THE TOP DASH COVER USING A FLAT TIP SCREW DRIVER AND LOCATE THE CONNECTOR FOR THE RKE MODULE. THE CONNECTOR WILL BE SMALL AND LOCATED NEXT TO THE HVAC DISTRIBUTION DUCT. MOUNT MODULE AND INSERT THE CONNECTOR. SINCE THE BODY CONTROL MODULE IS INVOLVED WITH THE RKE THIS MAY OR MAY NOT WORK BECAUSE NOT ALL CONTROLLERS ARE THE SAME BUT IF YOU WOULD LIKE TO TRY TO PERFORM THE TASK TRY THIS. FOR PROGRAMMING:

1. Using a functional key fob transmitter, unlock the vehicle and disarm the Vehicle Theft Security System.
2. Insert ignition key into the ignition switch.
3. Turn the ignition switch to RUN position without starting engine.
4. Using a functional key fob transmitter, press and hold the UNLOCK button for a minimum four seconds (maximum ten seconds)
5. While holding UNLOCK button, and before ten seconds passes, press and release the PANIC button. A single chime will sound to verify that the RKE module is set to receive the new Vehicle Access Code(s)
6. Within 30 seconds of the chime, press and release the "LOCK" and "UNLOCK" buttons on the transmitter at the same time. Then press any one of the buttons. The BCM will sound an abbreviated chime to acknowledge that the programming of the transmitter has been completed and was successful.
7. Repeat step 6 for all transmitters that will be used with this vehicle (up to 4 total)
8. Programming mode will last for 30 seconds. To get out of programming mode sooner, turn the ignition OFF. A single chime will sound to verify that the RKE module will no longer accept additional Vehicle Access Code(s)
9. When Vehicle Access Code(s) programming is complete, turn the ignition switch to the OFF position and verify RKE system operation using each key fob

SOURCE: 99 Pontiac Grand Prix 3.8 v6 Error code 118-

http://www.obd-codes.com/p0118

That will tell you what you need to know

Raymond Ramirez

• 333 Answers
• Posted on Jun 22, 2009

SOURCE: rotor replacement for grand caravan

there is a clip inside the cap, you need to remove the cap. you can use a small screwdriver to pry it up or tap it with a rubber mallet.make sure to reset the bearing after you are done and use alot of grease. tighten the nut and spin the tiretight. then back off to put the pin back... kindly rank me

SOURCE: 2000 grand caravan won't go above 70 mph. high rpms

First I need to ask is it a 4 speed or a 3 speed transmission. If it's a 4 speed when driving down the road pull it from drive to third gear. You shpuld hear the engine speed up if it does not then that means you have on 4th gear and you will have to take it to a transmission shop. If it's a 3 speed then just count the shift points if all 3 gears are present then drive down the road and see if the van goes into tcc. When you mean the rpms are high how high are they.

SOURCE: going over bumps with 99 grand caravan sounds like

Well..... Check the links, if they are OK it could be the struts. Links are common on these. The time you took to post this, you could have known the answer. Grab the link with your hand and if its loose and rattles, its bad.