I have a 2006 Chevrolet Silverado 1500. The truck did not come with the fog lights from the factory, but I have the factory lights. Looking at the wiring harness behind the dash, I see that the wiring appears to be there, but is not there behind the grille. Am I missing the wiring behind the grille? If so, can I buy the switch that would turn the fog lights on from the factory, and make that work?
SOURCE: hhr fog lights
yes it is you will probably have to have the bcm programmed for the foglight option if your gonna install like factory is
SOURCE: Replace the driver's side fog light bulb
put the car on ramps and I am pretty sure it comes out from the back underneath the car and if needed for any parts you can check out www.schramauto.com or call them at 1-800-292-1032
SOURCE: 2006 toyota rav 4 fog light bulb replacement
fIRST YOU SEE A RUBBER GASKET SURROUNDING THE HEADLIGHT PLUG IN THE BACK OF THE HEADLIGHT ASSEMBLY. pULL OFF THE GASKET AND LET IT HANG ON THE SURROUN DING HEADLIGHT WIRES. tHEN PULL OFF THE HEADLIGHT WIRE HARNESS BY GRABBING THE SOCKET (NOT THE WIRES). AROUND THE BULB IS A THIN SILVER HOLDING SPRING THAT LOOSENS BY SQUEEZING THE ENDS TOGETHER AND ROTATING IT. iT WILL LOOSEN AROUND THE HEADLIGHT. WHEN THIS HAPPENS THE HEADLIGHT WILL "FLOP" AROUND AND PULL IT OUT, REMEMBERING TO SEE HOW THE THREE CONNECTORS ARE LOCATED (I.E - IS ONE CONNECTOR AT 12 O CLOCK POSITION AND THE OTHER TWO ARE AT 9 AND 3 OR ARE THEY AT 3,6 AND 9, ETC.). rE-ASSEMBLY IS THE OPPOSITIE. tHE TRICK IS TO GET THE THIN SPRING WIRE BACK IN PLACE. YOU HAVE TO SQUEEZE THE SPRING AND RE-POSITION IT SO IT KEEPS THE BULB SECURLY IN PLACE
Having just changed the bulb, I would advise taking the whole headlight assembly out first. It is near impossible to feel or imagine how to change the bulb without seeing it. First, use a phillips screwdriver to take the single screw holding the strip off just below the headlight assembly. By doing so, you will now see the other two bottom bolts holding the headlight in. Take all four bolts out then disconnect the bulb from behind. Then proceed as above.
SOURCE: change a fog light for a 2006 LR3
There is a circular cover surrounding the fog light assembly that simply pops off. Behind that cover there are three maybe four torx style screw that need to be removed, then simply just disconnect the electrical connector to the fog light assembly.
SOURCE: replace fog light bulb for 2006 Honda Odyssey
Touring Model
Use a wrench to remove the mounting bolt from the underbody through the hole in the splash shield.
Remove the fog light assembly from the bumper by pulling its inner edge first, then the whole assembly out of the bumper.
Remove the electrical connector from the bulb by pushing on the tab and pulling the connector down.
Remove the bulb from the fog light assembly by turning it one quarter turn counterclockwise.
Push the electrical connector onto the new bulb.
Turn on the fog lights to test the new bulb.
Reinstall the fog light assembly into the bumper. Tighten the mounting bolt.
Insert the new bulb into the assembly and turn it one-quarter turn clockwise to lock it in place.
Hope this helps you.
157 views
Usually answered in minutes!
×