Hi, i have a 2003 sunfire and there are hr and min buttons but pushing them does not set the clcok and there is no clock set option and i dont know how else to do it pls help...

Make sure radio is off, then press on HR and min buttons located on the far right bottom corner of stereo buttons. Buttons are very small and so are letters. After setting time, push radio button on

I sugest check this procedure in the Pontiac Owners Manual (need free yahoo register).

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Turn ignition to "on" or auxiliary with radio off. Time will light up. Press and hold the "hr" button until the numbers move. Do the same with the "min" button. Good luck.

There are little buttons that say Hr and Min under the clock. Push/Hold them and it will change the hour and minutes.

Hello, here is the instructions for setting the clock

RDS Clock Time Broadcasters can choose to send clock time information in the RDS data. This information can be used to update the clock time on the radio. RDS clock time is broadcasted once a minute. To set the clock using RDS clock data perform the following:

• Press and hold the HR and MIN buttons together for two or more seconds to update the time.
• The display will show "UPDATED" after receiving the broadcasted time data. • If the broadcaster is not broadcasting the time data, the radio will display "NO UPDATE" and the time remains unchanged.

if this doesnt work, just simply push and hold the hr and minute buttons to set the time
• Press and hold the HR and MIN buttons together for two or more seconds to update the time. • The display will show "UPDATED" after receiving the broadcasted time data. • If the broadcaster is not broadcasting the time data, the radio will display "NO UPDATE" and the time remains unchanged.

Setting the Clock for AM-FM Stereo

Press SET. Within five seconds, press and hold the SEEK down arrow until the correct hour appears on the display. Press and hold the SEEK up arrow until the correct minute appears on the display.


Setting the Clock for All Systems Except AM-FM Stereo

Press and hold HR until the correct hour appears. Press and hold MIN until the correct minute appears. There will be a two-second delay before the clock goes into time-set mode, and the colon on the display will blink while in this mode.

If this is helpful, pleas rate this answer well.

as long as this is a factory radio am/fm only
there are 3 large buttons marked 1-2 3-4 5-6 they are preset stations
below there is another big button under the 5-6 preset
will have HR-MN an arrow pointing down under the HR an arrow pointing up under MN
HR hour MN min. PUSH AND HOLD HR to set hour and PUSH AND HOLD MN to set min. KEY ON OR OFF
hope this helps

Without knowing which radio you have??? I will guess. With the radio OFF, push the SET button, now use the Seek/Scan buttons to change the time. when done, push the set button again.

hi from uk ! to set clock/time on getz look t the speedometer ? you will see two buttons on the bottom of dial ? the left button is to cancel the trip meter by pressing button in for trip A and again for B trips the right hand button marked hr + min ? to set hour time turn to left untill hr time is shown then release now turn button to right to set the minutes then releas when time/minutes ar correct that is it! ps you cannot cancel the odometer/milage clock only trip meter hope this helps best wishes from n/west uk

Hmmmmm ...