Does my ford motorhome have a gas shutoff switch 1991 ford sprinter v-8 7.5 liter

There is no single torque specification for the injectors on a 1991 Ford F250 7.3 liter diesel IDI. Each injector has a specific torque spec, typically between 8-16 Nm.

A Ford inertia switch only trips if there is a large impact. The inertia switch is designed to stop the flow of fuel in an impact to try and prevent a fire or an explosion. If you are not getting fuel I would make sure the pump is good.

ground is generally black on most vehicles.

1991 Ford F 150 2WD Pickup
4.9 liter L6 VIN "Y"

Most likely there is air in the line that must be bled.


Thanks for using FixYa - a 4 THUMBS rating is appreciated for helping with your FREE question

You check the right firing order?

1991 Ford Mustang 2.3 liter SOHC L4





1991 Ford Mustang 5.0 liter V-8 HO



Also, need check the PCM for someone short; sometimes this is the reason it wasn't sending a signal to the coil. You have constant power at the coil but the ground signal doesn't fluctuate from on to off while the engine is cranking. If the hall effects switch in the distributor is bad it won't tell the PCM when to fire the coil and the hall effect switch also operates the tachometer. So if this switch is bad the tach and the coil would not work.

Good luck.

It is located at the left hand dash panel above the brake pedal.Hope this helps.Good luck.

Open the trunk and look in the left side panel there is a small opening where you can press down and reset the switch.

front passenger side kick panel. Basically right where the right foot would hit the side of the truck.

Check your vehicles safeties. Your ECM is probably programed for engine shutdown if it senses low oil pressure or low coolant level. Do a preliminary check.