Removal & Installation
2.7L
Engine
Negative battery cable from the remote ground post
Battery feed and posi-lock connectors
Nuts from the catalyst support bracket and mount
Starter heat shield
3 starter-to-engine/transaxle bolts
Starter by rotating it toward the engine and sliding it rearward
between the catalyst and the engine mount
To install:
Starter by sliding it forward between the catalyst and the engine
mount and rotating it away from the engine
Starter and torque the 3 starter-to-engine/transaxle bolts to 40
ft. lbs. (54 Nm)
Starter heat shield
Nuts to the catalyst support bracket and mount
Positive battery cable and torque the nut to 89 inch lbs. (10 Nm)
Posi-lock connectors
Negative battery cable to the remote ground post
3.2L & 3.5L Engines
Negative battery cable from the remote ground post
Starter-to-engine/transaxle nut and bolts
Positive battery feed wire from the starter
Starter and position it to gain access to the posi-lock connector
Fig. Removal and installation of the starter motor
To install:
Hope this help (remember rated and comment).
Posi-lock connector
Starter by sliding it forward between the catalyst and the engine
mount
3 left engine mount-to-engine bolts
Positive battery feed wire to the starter and torque the nut to 89
inch lbs. (10 Nm)
Starter and torque the starter-to-engine/transaxle bolts to 40 ft.
lbs. (54 Nm)
Negative battery cable to the remote ground post
560 views
Usually answered in minutes!
×