Hi my 2002 coupe key fob has stopped working

central timer module" - Dodge Dakota Forum

www.dodgedakota.net/boards/gen/21983.html

Jan 2, 2009 - 21 posts - ‎18 authors
I have a Dak 2000 3.9 Ltr V6, Single Cab, Bare Bones. ... Panic Mode .... ooops....i mean the remote entry and alarm system does NOT work ... i have a 2002 dakata where can i buy a ctm looked all over nobody sell them can thay be rebuilt ... I was out the door $550.00, and they washed the truck also.

Truck wont work/Key Fob won't work/wont start/wont do anything ...

www.ramforumz.com > ... > Electrical

Apr 10, 2010 - 10 posts
Truck wont work/Key Fob won't work/wont start/wont do anything! ... Maintenance & Repair > 3RD Generation Dodge Ram - 2002 to 2008 Dodge Ram Trucks > Electrical... Soon as I manually unlock the door, and open it.... the factory panic alarm starts going off. .... Vehicle: 2004 Dakota Club Cab 4X4.

alarm going off when opening the door.. embarrassing and annoying ...

www.cumminsforum.com > ... > 3rd Gen. Non-Powertrain

Jan 12, 2012 - 11 posts - ‎9 authors
how do I stop my trucks alarm from going off when I open the door? it did it ... to thetruck and opened driver door (it was unlocked) and the alarm started going off. ... I do not have a remote unlocking device (or it doesnt work) so I do all .... alarm will go off then I have to use the FOB panic button to shut it off.

Keyless entry/panic button/alarm - Dakota Durango Forum

www.dakota-durango.com > ... > Gen III Dakotas

the alarm will be deactivated by key in door lock unlock, the no start is not alarm, check security red led is on, indicating key programing needed

the key fob disables the alarm when you unlock it. either get a key fob or disconnect the alarm.
Launch scanner

Relearn the key fob,,turn key on,leave it on ten minutes,then turn it off,and right back on,for ten minutes,then off,and right back on,,do this one more time for a total of thirty minutes.

This reset for key fob Hyundai coupe year 02 to 04
Turn ignition to position two
Press lock or unlock once
Ensure indicators flash once to confirm reset
This will enable fob providing you have no other faults
Good luck barry

You have a burnt solenoid for lock on the drivers door.

It's sounds like the solenoud for the drivers door is shot, you need to chnage it.

i have a rover 25 and the key fob is not opening the car i could use the key to open it but the alarm will go off and cant stop it without the fob...

One day my Hyundai Coupe 2002 2.0 car alarm would not dis-arm. The remote was flashing but not turning the alarm off. I replaced the batteries and had the remote signal tested, but still the alarm would not dis-arm. There are no switches to flick off, no reset button and there was no way off cutting power to the alarm. The only solution was to take it to a Hyundai dealer ( with alarm siren sounding and lights flashing ) and have them disarm it. It took one guy almost 3 hours to disarm it, and cost me £150 ! I knew the guy at the garage, so that was with discount. The alarm is a joke and should not have been fitted in the first place by Hyundai!