Fault code P0340 .Some sensot on camshaft.My whife

Please understand the fault code you have, it doesn't mean the sensor is defective, many other factors cause this code. Go to the link please. P0340 Nissan Camshaft Position Sensor Circuit Bank 1

Camshaft Position Sensor Circuit Malfunction when you installed the harmonic balancer you may have damages a wire or sensor the following links will help with your p0340 code


https://www.obd-codes.com/p0340 How To Diagnose Check Engine Light Code P0340 Cam Position Sensor http://www.autocodes.com/p0340.html

2006 honda odyssey p0340

It is the camshaft position sensor A bank 1 code.
Here are possible causes:
- Faulty Camshaft Position Sensor
- Camshaft Position Sensor harness is open or shorted
- Camshaft Position Sensor circuit poor electrical connection
- Faulty starter motor
- Starting system circuit
- Dead (Weak) battery

Hi William,here's a link to your camshaft sensor,it is saying that it is built into your distributor.Here'a what it says about your p0340 code.

Hi there:
DTC P0340 - CMP (Camsahft Position) Sensor Circuit Malfunction

CHeck details HERE.

P1684 The battery has been disconnected within the last 50 starts.

P0340


This indicates that a problem was detected in the camshaft position sensor circuit. Since it says circuit, that means the problem could lie in any part of the circuit - the sensor itself, the wiring, or the PCM. Don't just replace the CPS (camshaft position sensor) and think that will definitely fix it.
Symptoms Symptoms can include:

• Hard starting or no start
• Rough running / misfiring
• Loss of engine power

Causes A code P0340 could mean one or more of the following has happened:

• a wire or connector in the circuit could be grounded/shorted/broken
• the camshaft position sensor may have failed
• the PCM may have failed
• there exists an open circuit
• the crankshaft position sensor may have failed

Possible Solutions With a P0340 OBD-II trouble code, diagnosis can be tricky at times. Here are some things to try:

• Visually inspect all the wiring and connectors in the circuit
• Check for continuity in the circuit wiring
• Check the operation (voltage) of the camshaft position sensor
• Replace the camshaft position sensor as required
• Check the crankshaft position circuit as well
• Replace circuit wiring and/or connectors as required
• Diagnose/replace the PCM as required

A fault code P0340 on the '05 Dodge Neon means, "No CAM signal at PCM." So the camshaft position sensor or its wiring is at fault.

The car will start and run without the cam signal, but it will run in "limp-home" mode and batch-fire fuel injection - So it'll run, just not very well...

First step, make sure the sensor is actually plugged in. It's on the driver's side of the head, looks like a square with a raised circle. Also check the wiring from it back to the computer and make sure it isn't shorting out somewhere. Replacing the sensor only takes those 4 bolts and a few rags for oil.

I'm not sure on the price of the part, but I don't think it's anymore than $50 or so.

I hope this helps and good luck! :)

P0340 Camshaft Position Sensor "A" Circuit Bank 1 or Single Sensor

P0700 Transmission Control System (MIL Request)

The code P1684 is real easy. The computer is stating that the battery has been disconnected within the last 50 starts.

I would think it would be just the Camshaft Position Sensor.I looked up the codes and they say pretty much the samething.


P0340 Ford Camshaft Position Sensor Circuit Malfunction


P1336 Ford Crankshaft/Camshaft Sensor Range/Performance