Passenger window won't work using the driver side control switch

Power Windows not working - CarGurus

www.cargurus.com > Questions > Honda > Accord

CarGurusOct 9, 2012 - Power Windows not working - I have a 2006 Honda Accord and thepassenger and back power windows quit working all at once. ... My key less entry doesn't work either after I replaced the master Window control unit. 6 out of ...

Passenger Power Window Not Working ' ClubCivic.com - Your Online ...

www.clubcivic.com > ... > Interior / Audio / Electronics

Oct 28, 2009 - My passenger side window is not responding to either the driver side orpassenger side switch. It is in the up position and wont go down.

the passenger switch need to be replaced

It sounds like it could be the window solenoid, or the window motor. It's unlikely the switches on both doors are bad. Check the solenoids and motors...

If neither switch works, the motor is the next component to check.

https://s14.postimg.org/6r7zxgtox/power_windows.jpg

Click on the link.
I can only help by telling you to check voltage and ground circuits. You check voltage by using a test lite, see the fuse in diagram, not only check the fuse, check the fuse circuit for voltage.
To check ground, you can still use the test lite, one end comes from voltage, the other end you touch to ground wire, the actual wire not the insulation, if the lite comes on, at least you know the ground is good enough to turn on the lite.
You can see voltage wire color coming from fuse. The ground wire not in the picture, black with yellow tracer.
on the hinge side of driver door is usually a wiring harness going into the driver door, probably has a protective covering, move cover back far enough to find the wire colors you want to check.
You open/shut driver door so much, sometimes those wires may break?

{: ) -- I think you are referring to the door lock/window master control switch. You cannot swap them, since the passenger door switch uses different connector and configurations compared to the driver door switch.

Visit the on-line store, known as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem.
Best Manuals

Passenger window lost programing. To reprogram, turn the key on, go to the passenger side and with the passemger switch run the window all the way down and hold switch in down position for 2 seconds, then run all the way up and hold in up position for 2 seconds, then repeat again within 5 seconds. Should work from drivers side master switch now.

Replace the Driver side window switch. These have a corrosion issue.

1. Turn ignition switch to "on" position.
2. Open passenger window completely from passenger side window switch.
3. Close passenger window completely from passenger side window switch, and hold switch for an additional 2 seconds.
4. Turn ignition back to "lock" position.

That's it. Works like a champ. And here you thought it was more than just a battery dying....I did.