Replace indicator bulb freelander td4 2005 - 2003 Land Rover Freelander

Check for relays and some bulbs, earthings.

If you can't find the screws, try opening the panel from the inside.

how to replace the bulb behind the cd player on a freelander 2 2007

The Freelander is Land Rover's entry-level crossover SUV. Unlike other Land Rover vehicles that use a traditional "truck," body-on-frame chassis, the Freelander is built on a unibody, front-wheel drive car chassis. The Freelander is sometimes known in the U.S. as the "LR2."

1 Purchase replacement bulb P21/5W, available at most auto parts stores and at any Land Rover
dealer.

2 Turn off engine and open rear cargo door.

3 Remove the two Torx screws from the side of the tail light assembly. Carefully pull the assembly
away and unplug the electrical harness.

4 Turn the assembly over to access the bulb modules. There are three separate bulb modules; the
top module should be the brake light.

5 Rotate the bulb module counterclockwise to release it from the tail light assembly. Push the bulb
down (into the module) and turn it counterclockwise to remove it from the module.

6 Insert the new bulb into the bulb module. Carefully push the bulb down and turn it clockwise.
Reinsert the bulb module into the tail light assembly and turn it clockwise.

7 Reconnect the electrical harness to the tail light assembly. Remount the tail light assembly and
replace the Torx screws.

brake pedal switch has ratchetted to far replace with new switch available from dealers.

Check/replace relay 6,located in fuse box lower dash under steering wheel.

Went to Halfords, spent £14.99 BOGOF & was shown how to do it!
So easy, girls - just undo cap, disconnect plug & unlock metal clip - remove n replace bulb, resecure clip, connect plug & put back cap! Saves you £4.99 a bulb!! DIY girls, just have your baby wipes handy lol

double check all bulbs are illuminationg (including the side repeaters / wing mirror repeaters) and check the fuses

This fuse is no.2 in the fuse box above the pedals and it should be a 15 amp.If you plugged a trailer in then check those electrics or check your brake light switch on the brake pedal.

Hi you get to the bulb from inside the hood, that thing that you see with cables is where the bulb conects to,turn the plastic thing counterciockwise and there is your bulb ,disconect the plug with a small screwdriver and get a new one , avoid touching the glass of the bulb with your fingers because the grease of the body may short the bulb life.(I hope this help)