How do i install a water pump for an Isuzu Rodeo, V.7 3.2 liter

Isuzu_Rodeo_Rodeo_Sport_1997-2004
Water Pump - Removal and Installation

3.2L Engines

1. Before servicing the vehicle, refer to the Precautions Section.
2. Drain the cooling system.
3. Remove or disconnect the following:
   Negative battery cable Upper radiator hose Timing belt. Refer to the Timing Belt procedure. Idler pulley Water pump

1. Install or connect the following:
   Water pump. Tighten the bolts in two passes, in sequence, to 18 ft. lbs. (25 Nm). Idler pulley. Torque to 38 ft. lbs. (52 Nm). Timing belt Upper radiator hose Negative battery cable
2. Fill the cooling system.
3. Start the engine and check for leaks.

1. Before servicing the vehicle, refer to the Precautions section.
2. Drain the cooling system.
3. Remove or disconnect the following: Negative battery cableRadiator hoseAccessory drive beltFront coverTiming belt. Refer to the Timing Belt unit repair section.Timing belt idler pulley Water pump
   Negative battery cable Radiator hose Accessory drive belt Front cover Timing belt. Refer to the Timing Belt unit repair section. Timing belt idler pulley Water pump how do i install a water pump for an Isuzu Rodeo, - e6f48ad.jpg

1. Install or connect the following: Water pump. Tighten the bolts in sequence to 18 ft. lbs. (25 Nm).Timing belt idler pulley. Tighten the bolt to 38 ft. lbs. (52 Nm).Timing beltFront coverAccessory drive beltRadiator hoseNegative battery cable
   Water pump. Tighten the bolts in sequence to 18 ft. lbs. (25 Nm). Timing belt idler pulley. Tighten the bolt to 38 ft. lbs. (52 Nm). Timing belt Front cover Accessory drive belt Radiator hose Negative battery cable


2. Fill the cooling system.
3. Start the engine and check for leaks.