Question about 1996 Jeep Grand Cherokee

1 Answer

1996 jeep grande cherokee: Interior lights will not go out after shuting car off.As soon as ignition is turn to off position they come on and will not go out. Checked swithes and changed body module.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 326 Answers

HAVE YOU CHANGED ALL DOOR JAMB SWITCHES IT SOUNDS LIKE YOU HAVE BAD ONE THINKING DOOR IS AJAR WHEN ITS CLOSED

Posted on Mar 17, 2010

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Keyless remote 1996 jeep grand cherokee laredo programing


Instructions
  1. Programming the First Transmitter
    • 1

      Unlock all of the Jeepicon1.png Grand Cherokee's doors and open the driver's side door. Keeping the door open, lock it using the manual lock on the door itself.

    • 2

      Put the manual key into the ignition and switch it to the "On" or "Run" position, whichever applicable, without starting the engine.

    • Sponsored Links

    • 3

      Point the remote at the receiver (located by the little bulb on the caricon1.png ceiling) and hold down the "Lock" button for up to 5 seconds.

    • 4

      When the driver's side door unlocks, you know the remote has been programmed correctly. If you are only programming one remote, jump to the next step. If not, manually re-lock the driver's side door and repeat steps 5 and 6 using each remote you would like to program and then continue.

    • 5

      Turn the key to the "Off" position and turn the ignition on immediately. This must be done within 20 seconds of programming the last remote. You're finished!

Sponsored Links

Read more: How to Program the Remote on a 1996 Jeep Grand Cherokee ' eHow.com http://www.ehow.com/how_7433787_program-1996-jeep-grand-cherokee.html#ixzz2KdCc5PQq

Feb 11, 2013 | 1996 Jeep Grand Cherokee

1 Answer

1996 jeep grand cherokee no automatic interior lights


1. If you have the light switch in the wrong mode the lights will not operate when you open the door.

2. If the interior lights do not operate at all (ie you cannot switch them on and off manually)then you need to check the fuse for the interior lights.

3. When set to the correct mode, the interior lights will operate from a door operated switch so if the switch has failed the lights will either stay on or not operate at all when you open and close the door. Eventually these door switches fail with repeated use and need to be replaced. (Consider how many times the small door switch has been operated since 1996).

Dec 25, 2012 | 1996 Jeep Grand Cherokee

1 Answer

1996 jeep grand cherokee, interior lights wn't shutoff


Have you tried checking the dimmer switch for your instrument panel? I believe if the switch is slid all the way up it will cause the interior lights to stay on. Hope this helps.

Aloha,
Kalani

Jan 28, 2010 | 1996 Jeep Grand Cherokee

2 Answers

96 jeep grand cherokee interior lights


YOU COULD HAVE A FAULTY DOOR JAMB SWITCH.

Oct 03, 2009 | 1996 Jeep Grand Cherokee

1 Answer

Interior lights will not turn off.


i had the same problem, it is a relay in your fuse box under the passenger side dash. i think it says courtesy lights on it.

Sep 06, 2009 | 1996 Jeep Grand Cherokee

1 Answer

96 Jeep Grand Cherokee won't start, has a good battery, lights don't dim when key's turned but nothing


check for ignition voltage at the purple wire in the starter when you open ignition to the crank position , with a test light,, if the light light on them you need to change the starter..

Aug 01, 2009 | 1996 Jeep Grand Cherokee

1 Answer

Interior lights won't turn off


one or more faulty door switches

Jul 30, 2009 | 1995 Jeep Grand Cherokee

1 Answer

Interior lights wont go out


First you can check your door adjar switches. Unplug one at a time to see if your dome light shuts off. If it shuts off replace switch that was unplugged. If this does not help your problem is the ignition switch. Thanks

Jun 08, 2009 | 1996 Jeep Grand Cherokee

2 Answers

The interior lights for my 1996 jeep grand Cherokee Laredo


Hello and welcome to FixYa
The interior lights wont turn off cant because it can't get a conncetion definitely a headlight switch issue common problem for that make
Part # 05137535AA Headlight Switch Probably a dealer item very simple to change this yourself. Hope this gets you going.Please Rate Me. And you can always Ask Me.
1ak+f4pj7cbm32cuniyi2gaaaaaelftksuqmcc

Apr 27, 2009 | 1996 Jeep Cherokee

1 Answer

Creepy flashing lights


Check the adjustment of the rear hatch. As you turn the car body flexes and if the rear hatch is not adjusted correctly the interior lights will come on.
As for the sunroof, without proper diagnose I can only guess (motor, relay, fuse ).

Oct 23, 2008 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
1996 Jeep Grand Cherokee Logo

214 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...