99 Corolla power windows not working

I would check to see if the harness that comes to the master switch is powered. Make sure the ignition is on or vehicle running and check to see if you get voltage reading with multimeter. If no reading then you need the wiring diagram to see where that harness should be fed.

Motor weak/ failing

your going to have to chase the short or grounding in the wiring on this one. it may be in the front driver door. had similar problem in my wife's 99 and turned out to be wiring in the door.

It is not a big deal. All the windows need re-learn after the battery is disconnected. To re-learn do the following steps:
1. Sit on a driver's seat. Switch on the ignition.
2. Push the window button to open the driver's window and and keep the button pressed for 3 to 5 seconds after the glass touches the bottom and release the button.
3. Similarly do the same to close the window.
4. Do the same with all the remaining windows one by one.
5. Now after all the windows are re-learned, they should now be operated with a driver's master switches.
Good Luck and thank you for visiting Fixya.

If all your windows don;t work then its your power relay under the dash right above, the flasher,the fuse block.My neighbour had the same problem.

Unfortunately, there is a trick to replacing the battery.
1) Open the Driver side door.
2) Open the Bonnet and take the battery cover off.
3) Use your remote to lock and unlock the car (keeping the driver side door open)
4) Pull the Negative Lead from the battery first, followed by the Positive Lead.
5) Change or replace with charged battery.
6) Closed down Bonnet.
7) Your windows, sunroof, and key FOB will not work... so follow the next steps.

7a) Insert your key, with door closed into the exterior lock on driver's side.
7b) While turning the key to lock the door, hold down the "lock" button on your remote for 5 seconds while in "lick" position
7c) Your remote will reset, and you should be able to use your remote now
7d) While driving, roll each window down twice. On your third attempt, you should only have to touch the window button, and the window will have reset

Enjoy your Rover!
MIke

remove the door panel and check for power and ground to the motor if you have that then try tapping on the motor while working the switch sometimes they get stuck

it could problem with wiring with fr rh door check connector is lose or it moved out, that can only be the cause.

would need car in front of me and my oil can in my hand to clean the mechanism of accumlated dirt around the springs and the whatever and a nice drop of real oil and not that fish oil od wd40

Your chevy uses two fuses for the system. The power lock actuators are on the 15 amp fuse inside the truck. The fuse for the switches (locks and mirrors) are under the hood. For 99 to 04 (I think those are the years) there is a TSB on replacing the 3 amp fuse under the hood with a 5 amp fuse because this is a well known problem of having these blow.

Your drivers side window is a different issue. If the rest are working your problem is in the motor or getting power to the motor. The wires that go from the body to the door often crack and break with the opening and closing of the door.