2000 subaru forester ignition coil wiring

The firing order for the 2015 Subaru Forester 2.5i is 1-3-2-4. This means that the spark plugs will fire in the following sequence: first cylinder, third cylinder, second cylinder, and fourth cylinder.
The firing order of an engine refers to the sequence in which the spark plugs ignite the fuel in the cylinders. The firing order is determined by the engine's design and is important for ensuring that the engine runs smoothly and efficiently.
In a 4-cylinder engine like the 2015 Subaru Forester 2.5i, the cylinders are typically numbered from left to right, starting at the front of the engine. The firing order for a 4-cylinder engine is typically 1-3-2-4 or 1-2-3-4, with the spark plugs firing in a sequence that alternates between the left and right sides of the engine.

How to troubleshoot no spark condition with test light Subaru


Igniter !

its to the right of the ignition coil pack under the wires on the drivers side.

bibby1 image

You have problem with coils or fuel filter,could be good time to replace.

Take it to your dealer/mechanic...there may be more damage than you think.

You only need to change them if you are having problems such as miss firing engine etc.

possible ignition problem check ignition coil wires and spark plugs

coils might be gone ...mo dual in Distributor where the wires lead to is most likely gone ,take off cap and rotor ...unplug the mod dual un screw two or three screws to remove mod dual ...replace ...

It's likely the coil. Subaru issued a TSB (Technical Service Bulletin) on this issue. This is not a recall but you may want to show this to your Subaru mechanic or call Subaru after your repair to try to at least defray some or all of the cost for the repair. The link is below:

Subaru Forester Ignition TSB

probably a ignition problem,start the engine and spray water on the ignition coil and spark plug wires you should see some lighting bolts!