1995 eclipse timing missing Plz Help!

Ignition switch could be bad or fusible link wire.

alex metro u get problem fixed if so wat was it i got same problem in my rs email me at [email protected]

in order for an engine to run, you need compression, fuel, and spark. you are probably missing one of these 3. remove your air tube from the air filter box .eand spray starting fluid, or brake cleaner into the throttle body. if it starts, you pave a fuel problem. i e fuel pump of pump control

The Exhaust Gas Recirculation (EGR) system is used to reduce Oxides of Nitrogen (NOx) in the engine exhaust. This is accomplished by allowing a predetermined amount of hot exhaust gas to recirculate and dilute the incoming air and fuel mixture. This process reduces peak flame temperature during combustion. The system uses a vacuum-controlled Exhaust Gas Recirculation (EGR) valve, in order to modulate exhaust gas flow from the exhaust manifold into the intake manifold.

i hope this helps you
plz vote comment if need more help reply

Go to your local auto parts superstore and ask them to hook up the OBD scanner to read the fault codes. Or your mechanic. Hope this helps.

Hi, it might be that the engine control unit fuse has blown. You will have to check all the fuses as most of the systems in the vehicle is integrated with the engine control circuit. If all fuses are fine you will have to take the vehicle to a dealer in order to code the key to the anti-theft unit. This unit gives the engine control unit authorisation to activate the fuel and ignition systems.

It should be a sticker on the hood or on your strut tower in the engine compartment area....looking up the diagram for you though....what size motor?

Have the timing checked , you may need a new
timing belt if its worn out or miss aligned nothing will
fix this problem but a new belt .. so have that checked .

Start by checking the fuses then move to the light bulbs. If those are ok check the flasher switch and then the turn signal switch. More than likely you will need to replace the flasher switch.

This sounds like the timing belt is shot. Remove the distributor cap, have your helper crank the engine. Is the rotor turning?? If not, then it is the timing belt. Some engines are rather forgiving when the belt breaks, some will get bent valves. Frankster016