E 270 CDI. ESP and ABS warnings.

Try pressing the ESP button for 3 seconds, (See photo), to check you haven't pressed the button by accident. If not, try this website.

Mercedes ESP light warning How to RESET it yourself

Sounds like you have a speed sensor problem. Possibly input or output shaft speed sensor on transmission. You will need to find out what fault codes are being set and proceed from there.

check if it needs brake job.

What does 56 plate mean?

Whenever this warning or any other stays on in the dash it is indicating that the systems control module has detected a fault, it then disables the system as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Check & replace if necessary the brake pedal switch placed above pedals on the support.
If the problem still occurs you might access the ABS & ESP ECU (Electronic Control Unit) using diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC (Diagnostic Trouble Codes) memored.
Then you will be able to replace bad piece(s) and fix the problem by erasing all DTC stocked inside ABS ECU & reset it.

The ESP system means the Electronic Stability Program. If the ESP lights on the dashboard permanently the ESP system is faulty. You must access the ESP Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: brake pedal switch, front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP ECU, in other words reset the ESP system and turn off the warning lamp on dashboard.
I'm convinced that your brake pedal switch is faulty because the glow plug warning sign went ON after ESP warning light. Just replace the brake pedal switch, see if rear stop lamps light when press the brake pedal, and test the car on the road.
Good Luck!

The ESP system means the Electronic Stability Program. If the ESP & ABS lights on the dashboard permanently the ESP & ABS system is faulty. You must access the ESP & ABS Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car (placed in dashboard, under a plastic cover above the ashtray). Then you will be full informed about bad pieces (e.g.: front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP & ABS ECU, in other words reset the ESP & ABS system and turn off the warning lamp on dashboard.

• you need a Brake safety switch replaced.This is located behind you brake pedal.it's a common problem. The warning lights will reset after a few engine starts.

my power steering light comes on and off, and the car will not switch on once turned off, its draining the battery??

abs esp warning light coming on peugeot 407

I had the brake light switch replaced by a local dealer. Cost was $140 and it fixed the problem. Have driven the car for two weeks since and no lights and all systems normal.