Why would normal idleing vehicle stall and loose power for a 99 chevy s-10 with a 4.3 liter pickup
The fuel filter is located on the driver's side of the vehicle, at the front corner of the truck bed.
Its on the drivers side frame rail, under the car.
SOURCE: where is the oil filter located on a 1993 chevy
look by the front driver side fender inside the engine compartment. it's not on the engine but on the fender.
SOURCE: need wiring diagram for the ecm on a 94 chevy s10
Throttle Position Sensor (TPS) is connected to the throttle shaft on the
throttle body. It is a potentiometer with one end connected to 5 volts
from the VCM and the other to ground. A third wire is connected to the
VCM to measure the voltage from the TPS. As the throttle valve angle is
changed (accelerator pedal moved), the output of the TPS also changes.
At a closed throttle position, the output of the TPS is low
(approximately 0.5 volts). As the throttle valve opens, the output
increases so that, at wide-open throttle, the output voltage should be
approximately 4.5 volts. By monitoring the output voltage from the TPS,
the VCM can determine fuel delivery based on throttle valve angle
(driver demand).
Fig. 1: Common Throttle Position Sensor (TPS) wiring diagram (wire
color, terminal identification/location may vary on certain models)
In addition, I send you some wiring diagrams that coud helpful (click image for zoom)...
Fig. 7: 1996 GM 4.3L Engine Schematic
Fig. 10: 1996-1997 GM S10/Blazer Chassis Schematic
Hope this helps.
2,319 views
Usually answered in minutes!
×