At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
What happens if you give it a little gas ? Hold the RPM's up , will it keep running then ? How does it Idle , smooth or ruff ? Does the idle seam low ?
What is the vehicle specifically? Jerking when letting off during hard or mild acceleration could indicate a problem with an engine or trans mount. More severe cases its indicative of a loose, worn, damaged drive shaft or pinion. If front wheel drive car, lean toward engine mounts. But to clarify again, we need details of your situation to help more effectively.
Cars not control choke themselves electronically, this is likely the car trying to warm itself up quickly. The jerking will occurs anytime you shift into gear at an RPM over a low idle as the torque converter is being engaged. If the high idle last more than a couple of minutes then you might have an issue.
This truck is fuel injected, the problem sounds like a weak fuelpump, it runs when you pour gas into it until that gas runs out, the first thing is to test the fuel preasure, if the pump is weak it may run with gas poured into it but wont idle, also a common problem is the coolant temp sensor and the ground wires to thermostat housing bolt but i wont bet its the pump inside the fuel tank, if you put a fuel gauge on it there should be at least 55-61 psi if its a few pounds lower it can cause problems, you have everything else and it runs with gas poured so its a fuel problem check the preasure, theres a valve up top on the fuel line to connect a fuel gauge to it, start there hope this is helpful.
This is a rare one and can be tricky. Since your rpm gauge rises back up when you increase your acceleration slightly but you feel no jerking of acceleration then this tells me that a speed/rpm senser either has a bad connecton or the sensor itself is going bad when the engine reaches an optimum heat while driveing on the highway. Since you feel no acceleration when you slightly press the accelerator down but yet the rpm gauge is increasing back to normal, the throttle body sensor may be compensating for the failed speed sensor/failed sensor connector. Please get your uplander diagnosed properly first to confim this.
Jerks
×