How to remove the door panel on a 2005 grand prix

Videos in the link

https://www.google.com/search?q=2005+Pontiac+Grand+Prix+GTP+V-6+3800.+How+to+change+the+front+valve+cover

..

Instructions

1. • 1Roll the door window all the way up. Disconnect the car battery's negative cable with a wrench.
     
   • 2. Remove all cover plugs on the interior door panel with a putty knife. Remove all armrests, door pulls, the window crank and trim-panel retaining screws with a screwdriver.3. Remove and disconnect any electrical devices in the door panel. Pry the controls out with a putty knife, and unplug the wires.
     

4. Pry the trim-panel clips loose with the putty knife. Do not pry on the panel between the clips, or the panel could be damaged. Separate the trim panel from the door slightly, and disconnect the courtesy light. Remove the panel from the door.

Remove all screws visible. Pop off window/lock control. Then take a large flat tipped screwdriver or pry bar and gently pry around door panel until it pops loose. Then slowly lift it up and off of the door.

Hi,

Click on this link to find the lowest prices in the U.S. They will ship the part to you UPS.

2002 Pontiac Grand Prix Door Panel

All the best,

Ben

YOU HAVE TO REMOVE RIGHT SIDE HEADLIGHT HOUSING TO GET TO HORN.

u can just remove the switch plate

On the inside trim, you can remove screws (these screws may be covered by filler pieces or may be visible, or they may require you pry a plastic piece off that covers the screws) that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring.

no its a bolt on, must remove wheel brake caliper and its braket then brake rotor, look at back of spindle you will see 3 bolts ,remove them and hit frt of hub until it comes out . good luck.

you will need to remove the door panels and see why the linkage from the handle to the latch is not operating. Often, the linkages are held on by thin metal clips or nylon bushings that break over time.

should just be a philips screw
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door