Check voltage and ground for the outlet. The black wire is ground, the other wire is voltage, hot all the time. Use a test lite to check. Usually with outlet, the center of socket is voltage and the side of socket is ground. The voltage circuit is fuse protected, my info says fuse 6--20amp, in the integrated power module under the hood. Not only check the fuse, check voltage on fuse circuit, hot all the time, use test light.
Fuse six is the front, not the rear.
×
-Check to see if any fuse that supply power to it..? If it is then is the fuse blown or not. If it's blown then replace with new one.
Good luck
Mai
SOURCE: fuse for stereo/cd in chrysler town and country minivan
Its in the box next to the battery and i had the same problem.The fuse is on the first line top.
Thanks
SOURCE: On Chrysler Town and Country van keys were locked in the car and
does this van have factory theft device? if so you may have to reset to get the ramp working
SOURCE: 12 volt Power outlet in Chrysler Mini Van does not work
im sure of a fuse somewere and its probably a large one.
if the unit shorts it has to have a fuse first thing.
you may find a fuse under the hood in the fuse box.
and then you may find a fuse in the unit itself .
the other thing is to remove it and connect it to another car battery.
if you have a bad unit then a salvage yard in your area should have one.
also test the power in your car going to the unit.if its set to run all the time then theres a fuse at the battery or the fuse box.
one other thing is check for recalls
you may get lucky.
hope this helps
jm
SOURCE: i need to change front brake pads
You have two bolts to remove the caliper (it will still be attached to the flex hose). then use a C clamp to compress the caliper piston (one side on outside brake pad the other end on the back of the caliper). Inspect other components, replace pads and reinstall. I would highly recommend replacing rotors as well or at least having them turned. Its a pretty easy job if you have done similar jobs in the past.
SOURCE: Chrysler town and country Memory Seats
Memory selector is on driver's door, First set driver 1 seat and mirror positions, then press and release memory "s" button. then press and release memory selector "1" button. repeat for # 2 driver substituting memory selector 2 in step 2. hope this will help you
Testimonial: "Thanks so much . Your advice was spot on."
312 views
Usually answered in minutes!
×