I NEED DIRECTIONS ON HOW TO CHANGE THE LIGHT

test the socket

Some bulbs can be changed without removing the tail light. First check to see if there is an access panel in the trunk trim near the tail light. If there is, you can twist the turn signal socket counter-clockwise to remove it from the unit. If there is no access panel you will have to remove the portion of trim blocking the tail light. This is usually held in by a few small clips. After it is removed you can follow the directions above.
Lastly, some models have to have the tail light removed to change a bulb. The bolts will either be behind the trunk trim or on the inside edge of the tail light.
Once the bulb is changed just reverse the steps to put it back together.
Good Luck!!

Open the trunk, inside the trunk is a liner. Pull the liner back and you'll see the wiring going to the back of the light. Remove the light bulb retainer by unscrewing it and change the bulb.

you want to change the turn signal light? front yes to what ever side you need to change the access is to the back of the head light assy. Front Turn Signal Light Bulb Size: 1157A
Rear Turn Signal Light Bulb Size: 1157 check too owners manual will show you how to thanks Lee let me know how it goes thanx

You will need to remove the glass to get to it.

Muth Co signal mirrors have some good directions for getting the door panel off, and removing the glass, available for download on their site.

I prefer to do this with the mirror head off the truck, but you might feel other wise on this part.

Once you have the glass from the mirror removed you will see where the bulb is inserted from the back ( inside ) of the mirror head.

If you're after changing the bulbs, then here you go. Raise the hood. Looking at the top of the headlight assembly, you will see either one or two pins that are shaped like an upside-down "L". You'll only see the part that goes across. Pull the pins up, and pull the assembly foreward, out of the body. Disconnect the wires, and set it aside. Look at the turn signal from above. There is a plastic clip that you have to push in on, and then the turn signal housing will swing away from the body. You can then change the bulb. After you're done, but it back like you found it, and you're good to go.

1. From under front wheelhouse, remove access cover behind park and turn signal lamp
2. Through access hole in wheelhouse, rotate park and turn signal socket counterclockwise one quarter turn.
   1. Pull socket from back of lamp.
   2. Pull bulb from socket. INSTALLATION
      
      1. Align key on bulb base to groove in socket and insert bulb into socket.
      2. Through access hole in wheelhouse, insert socket into back of lamp.
      3. Rotate park and turn signal socket clockwise one quarter turn.
      4. Install access cover and verify lamp operation.

Hope this helps with your prob

There is one 10mm Bolt on the top of the light and three 10mm nuts on the back of the light. You will need to use a 10mm wrench to remove the nuts because they are in a tight place.

After the 1 bold and 3 nuts are removed, the entire headlight assemble will pull straight out. You don't need to take the headlight bulb out because there should be enough wire to pull out the assembly far enough to get to the turn signal bulb. This will allow you to change the turn signal bulb which should be a 4157 amber bulb.

When putting the headlight assemble back in the van, there is a plastic pin in headlight assembly that goes into a hole in the front fender for alightment. Don't force the light. Take your time and the headlight assembly will go back in the van smoothly.

the back light is blown. change it.