The left rear tail lights do not work. the Brake

Light bulbs require power and ground in order to work. The ground circuit for the left rear combination lamp is shared between the turn lamp, stop lamp and tail lamp. Because the tail light still works in that specific combination lamp, we know that the shared/common ground for that assembly is OK. The power circuit for both stop lamps (left and right) have the same origin; voltage flows from the STOP LP FUSE (15A) through the DBC RELAY (when the stop lamp switch is pressed) and then to each stop lamp via their respective circuit branches. Because the right stop lamp works, we know that the shared/common fuse, relay and switch are all OK. I'd suspect an open in the left stop lamp power supply branch and would recommending checking for voltage on the green & black wire at the left rear combination lamp assembly to confirm. Regarding the left lamp on the hatch, the wiring diagram indicates these are not stop lamps rather tail lamps only. I'd recommend installing a tail lamp bulb instead of a brake light bulb into that assembly as a first step. You can read more here: https://www.yourmechanic.com/article/how-to-replace-your-car-fuse-box-by-jessica-howe

The turn signals and brake lights use the same circuit and filament in the bulbs. The tail lights are on the other circuit which comes from the headlight switch.
Do you have power on the tail light fuse ?

first of all check and confirm whether in the fuse box separates the left from right side and see for blown fuse. or check for any disconnection on the rear light

Most certainly a wiring fault, you need a wiring diagram, these items are related as in all on same circuit. Check rear of fuse box.

does the high mounted brake light work? the brake switch has 2 contacts one for the high mount (LT BLUE/BLACK) and one for the tail brake lights. The tail/brake light wire is LIGHT BLUE. the main connector between the brake light switch and the tail lights is C208 which is located behind the rear seat, left side. So if there is power coming out of the brake switch OK and no power at the tail lights, check that connector. Hope this helps.

did you check the VEH STOP fuse? #34, 15 amps, in the rear fuse block, under the left rear seat.

you prob got a trailer plug prob bad wires if not tail lights run through turn signal switch tell fix ya bout me ok

most rear tail lights and turn/stop lights are the same dual filiment bulb. it is possible for your tail light to work and your brake light not to and still have a bad bulb. I would check the bulb first, your brake light works on the left yes? this would mean that the fuse is fine

These are Dual Function Bulbs. They control the Parking Lights and the Brake Lights. This Bulb is Burnt out on the Brake Coil inside the Bulb. I have actually seen Bulbs that were Bad But you could not Tell by jast looking at them. It should be fine with a New Bulb. Please Rate My Response! Thanks!

There was a recall on this, take to the dealer and they will replace the whole socket on this.