At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Vehicle Historyhttps://www.vehiclehistory.com > questions > how-do-...
With the key still in the run spot, wait 10 minutes, and the safety light will flash and then go out. Turn the key off and wait for 5 seconds. 8 answers · Top answer: The anti-theft system on the Dodge Nitro was not designed to be reset by the owner and requires software for a hard reboot that can only be acquired through ...
JustAnswerhttp://www.justanswer.com > Dodge Repair
Dec 26, 2016 · 1 answer
you cant reset them this is a common issue with dodge vehicles the wireless control module has gone bad. it wraps around the ignition cylinder ...
Your check engine light flashing means that the on-board computer has detected a problem, as a result there is now a Check Engine Light (CEL) code which you can have retrieved using a code scanner. Many auto parts stores will come out to your car and retrieve the code for you for free. Call around and find a parts store to do this, or obviously any mechanic with an OBD-II scanner can do the same thing. Once you have the exact code we can help more.
Hey guys I have a 2011 Dodge Nitro 3.7 and today my engine light came on and it was running like I was on rumble strips. I floored it and it sputtered and ran terrible then the light started flashing then I cut it off tried to reset still the light came on. I put the scanner on it and it turned out to be the coil plug on the #3 cylinder. COIL PLUG. Hope this helps out GOD BLESS!
change your starter solenoid!! its on the starter and has small wires going to it! it is stuck in the out position and it is very bad for your flywheel!!! so don't attempt to start no more and replace
Directions are in the book, but you would put the key in and turn it all the way, just don't start engine. Pump gas pedal all the way to the floor 3 times slowly, but it has to be with 10 seconds. Turn key off and when you start again, oil changed chime and warning should not be on. If it is, try again.
make sure gas acp is on tight this is a 80% problem most of the time drive it for a couple of miles and might turn off light if not you might have a bad sensor. but do the gas cap first just make sure its on tight make sure it clicks
×