How to remove rear axle to replace axle seal on chev 2004 k2500 truck?
First the wheel has to be removed. Then it's a good idea to remove the braking hardware(Shoes, springs etc.) for these will have to bre cleaned or replaced later in the process. There will be 4 or 5 hex head bolts circling the axle, remove these and at the same time place a small tray underneath to catch any small amount of fluid which may drip out. Next pry the axle out with your hands or a couple of matching prybars at 3:00 and 9:00 equally. The seal may be removed using a long, large flat head screwdriver blade. Use extra care not to scratch(score) the seal housing. The new seal should be installed using a seal and bushing installer kit, however, it may be done by using the old seal flipped iover and taped at a rotational method. Make sure after all is put together to measure the fluid level. This is done by placing your pinky finger into the filler hole . If there is enough fluid to coat your fingers firest knuckle than you're all set. Thank you, Dana
YOU NEED A HAYNES OR CHILTON REPAIR MANUAL.TO REMOVE REAR AXLE YOU HAVE TO REMOVE REAR DIFFERENTIAL COVER AND GASKET.YOUR DIFFERENTIAL HAS EITHER PINION SHAFT LOCKING SCREWS OR C - LOCKS.THEY HAVE TO REMOVED BEFORE AXLE SHAFT WILL COME OUT.
918 views
Usually answered in minutes!
how do i remove a rear axle
how to remove axle on champion trike
×