Where is the fuel pump located on 1998 Plymouth Voyager and how will I gain access to it because I'm not having any fuel pressure in the fuel rail. The van is trying to fire and runs for a second then stops.

The in-tank fuel pump module contains the fuel pump and pressure regulator which adjusts fuel system pressure to approximately 49 psi. (338kPa). Voltage to the fuel pump is supplied through the fuel pump relay.
The fuel pump is serviced as part of the fuel pump module. The fuel pump module is installed in the top of the fuel tank and contains the electric fuel pump, fuel pump reservoir, inlet strainer, fuel gauge sending unit, fuel supply line and pressure regulator. The inlet strainer, fuel pressure regulator and level sensor are the only serviceable items. If the fuel pump requires service, replace the fuel pump module, using the following procedure:

1. Remove the fuel filler cap and properly relieve the fuel system pressure.
2. Disconnect the negative battery cable.
3. Remove the fuel tank assembly from the vehicle.
4. Clean the top of the tank to remove any loose dirt.
5. Using special tool No. 6856 or equivalent, remove the fuel pump locknut by turning it counterclockwise.
6. 1. Remove the fuel pump and O-ring from the tank. Discard the O-ring.
   
   To install:
   
7. Thoroughly clean all parts. Wipe the seal area of the tank clean. Place a new O-ring in position on the pump module.
8. While holding the fuel pump module in place install the locking ring and tighten to 43 ft. lbs. (58 Nm) using special tool No. 6856 or equivalent spanner-type tool.
9. Install the fuel tank assembly.
10. Reconnect the negative battery cable.
11. Fill the fuel tank with fuel. Install the fuel filler cap. Turn the ignition switch to the ON position to pressurize the system. Check the fuel system for leaks.

The fuel pump will be located in the fuel tank. It is a tough job to access alone, in the driveway.

Its in the fuel tank....I just changed mine and that still wasn't the problem :( I'm lost