Check engine on jeep grand cherokke 1995

There are two fuse boxes.The fuse box is under hood in engine compartment and one more fuse box under dash . To see fuse box diagram,click the link below:--- http://technoanswers.blogspot.com/2011/10/1995-jeep-grand-cherokee-limited.html
---------- This should help.Thanks.Helpmech.

Thread Grand Cherokke, but ask about Cherokee ???

Make: JEEP
Model: GRAND CHEROKEE - LIMITED
Year: 1996
Engine: V8 - 5.2L - FI - - GAS
Part Number RC12YC
GAP .035" (Original Equipment Manufacturer and/or Original Equipment Equivalent)

Engine: L6 - 4.0L - FI - - GAS
Part Number RC12YC
GAP .035" (Original Equipment Manufacturer and/or Original Equipment Equivalent)


Make: JEEP
Model: CHEROKEE
Year: 1996
Engine: L6 - 4.0L - FI - - GAS
Part Number RC12LYC
GAP .035" (Original Equipment Manufacturer and/or Original Equipment Equivalent)


Hope this helps (remember to rate this free answer ans leave some testimonial).

sounds as though there is a leak, check all connections on a/c lines, now you will need to see if the clutch is getting power, if it is then the clutch will need replaced, if not then check to make sure where the fuses and relay plug into are receiving power. Hope this helped Tim

Base (initial) ignition timing is NOT adjustable. Do not attempt to adjust ignition timing by rotating the distributor. All ignition timing functions are controlled by the Powertrain Control Module.Adjusting the timing on a Jeep Grand Cherokee requires special tools and an understanding of engine mechanics. Changing the timing on a Jeep Grand Cherokee with distributor-less ignition requires professional reprogramming of the powertrain control module. This guide covers Jeep Grand Cherokee models with distributed ignition only. you can go to this site and it will explain it. www.ehow.com/how_4521340_adjust-timing-jeep have a good day !!

What everyone should have been doing for the last 30 years,
but don't
Any check light, is a govt mandated light, and a possible
system malfunction
Check for codes,diagnose,find solution to issues ,and repair

http://www.denlorstools.com/autoblog/2009/08/jeep-grand-cherokee-scanned-p1281-fault-code/

Do you have 2wd or 4wd and 2.5 or 4.0 also need email address to send diagram to

You will need a OBD 2 scan tool to retreve your code.If you hve not one go to a garage they will retreve the fault code for you.However you might consider makeing the purchase of one through a car part store near you.

Around $200.00

Have a great day !

This one is a pain. You have to remove the head liner. This will give you access to the panel. I would recomend buying a chilton or haynes manual from your local auto parts house. This will make future repairs much easier with pics and detailed instructions. Have a great day. If any more questions please ask