2006 range rover sport door lock problem

Passenger door has a cover if removed it exposes the manual key insert to open the door with the ignition key

There is a sequence of left and right turns of the key in the driver's door that will reset your bECM (Rovers brain) if the following have been tried.
1. Replace batteries in remote and 're-sync by depressing lock button on remote while physically turning and locking the door. Don't release button until locked and key removed. Repeat for unlock button.
2. Disconnect negative/earth cable from battery. While disconnected open driver's door, turn ignition to position 2, return to battery leaving driver's door open and reconnect the negative cable. Proceed to ignition. Turn off completely. Close all doors and hood and attempt starting.
Should both of these methods fail, run a search here on fixya for "engine disabled Range Rover P38" This will take you to step by step instructions on resetting the bECM which I opened this post with. It has been covered many times here, including by myself, no reason to post it again.
Good Luck!

ck for binding linkage to lock actuator, also full motion of actuator

pull the plastic cover off the back of the door handle ,it covers the door lock

it's underneath the driver seat. bring it forward to maximum and then put ur hand gently underneath. The Drive has a little door to be open by a button before you can be able to eject the disc.

Unfortunately, there is a trick to replacing the battery.
1) Open the Driver side door.
2) Open the Bonnet and take the battery cover off.
3) Use your remote to lock and unlock the car (keeping the driver side door open)
4) Pull the Negative Lead from the battery first, followed by the Positive Lead.
5) Change or replace with charged battery.
6) Closed down Bonnet.
7) Your windows, sunroof, and key FOB will not work... so follow the next steps.

7a) Insert your key, with door closed into the exterior lock on driver's side.
7b) While turning the key to lock the door, hold down the "lock" button on your remote for 5 seconds while in "lick" position
7c) Your remote will reset, and you should be able to use your remote now
7d) While driving, roll each window down twice. On your third attempt, you should only have to touch the window button, and the window will have reset

Enjoy your Rover!
MIke

body control module

I have a 2002 land rover discovery and my passenger front door won't unlock with the interior lock button on the dash or with the key fob. The only way to unlock the door is to pull the handle on the inside of the door. Is the actuator bad?

Please help
Rover2163

This car is in super lock mode... when you press remote 2times to lock or when you lock with remote and try to unlock using key manually.

there is a 4 digit number to open the door, its like opening a safe, starting from the left(key in car door) it goes L/R/L/R. so if number code is 1234..... left 1, right 2, left 3, right 4.

or if this too troublesome you can ask landrover dealer to remove the KEYCODE.

happy trying.....
adrian/kk.

I'm haveing a problem with my 2006 RR Sport car alarm. I can lock the door with the remote, but my alarm keeps going off. It stops but continues to go off during the day. The only message that I have received in the recent month is that my "Bonnett was open". Found out my Bonnett is the hood. Made sure the hood was closed tight and I have not received the message. But the alarm keeps going off.