Where can i find a wiring harness for my computer on a 1994 corvette?

Are you trying to use your harness and ecu from the existing v6? Please say no cuz the ecu for a v6 will not work well for the v8. I would suggest getting the ecu harness from the vette you got the motor from. GL.

The most common issue is a broken wire or wires inside the plastic insulator of the wiring harness that runs through the rubber boot from the door to the body.

unplug blower run hot wire to blower see if it works if does it resistor nif not it blower

There are two bolts in the front and two bolts in the rear, remove them and then disconnect any wiring connectors and pull the seat up and out of the car, careful not to damage the dash or body panels.

hooked up the harness, right? Is the rotor back in? the only other thing is it is not lined up properly, and you will have to get the engine to #1 compression at TDC and pull the distributor, line the rotor up to #1 wire on the cap.

yes but it will be difficult. a wiring harness swap will probably be needed since 93-94 were the experimental years for computers. you may need to swap trannys also. i advis you to have fun, the 5.7L chevy is one hell of a hot engine :) its the same one used in corvettes and comaros.

trade spark plug wire with another see if u get spark then

even though the LT 1 from the Z28 camaro and the corvette are similiar that is where it ends. Each car is programed differently, From the fuel pump to the o2 cencers. Alot of the wire connections will not match up if you do not change the wire harnesses. The computer might get fried if you try to "short cut" this project. Granted "some" parts are interchangable. Use caution when trying to interchange engines and transmissions. Aftermarket parts are avaible to make the swap easier. But its better to have a pro. do the swap and keeping it emissions legal.

The wiring harness will be completely different as well as the engine mounting locations. The computer will also need to be from an LT1 Camaro.

check for the wiring diagram or manual at autozone.com they have had most of them i have had to search for ..... [email protected] good luck