Where is the camshaft sensor located on my 99 Jeep Grand Cherokee

Jeep Crank Sensor Replacement, P Codes P0351, P1391 ...

? 6:24
www.youtube.com/watch?v=7D0vUEDSwXo
May 12, 2013 - Uploaded by Robert DIY Replaced the crank sensor on this 2003 Jeep Grand Cherokee.... to replace my crankshaft position sensor on my 1998 grand cherokee laredo.

Jeep Crankshaft Position Sensor Replacement (CKP, CKPS ...

? 4:07
www.youtube.com/watch?v=1Ho5iAKQV00

Oct 27, 2013 - Uploaded by WeekendHandymen
hi , do you think if I replace crank sensor will solve the problem ,my jeep .... Where's the crankshaft located in 99 jeep grand Cherokee laredo .

most cars its on the end of the cam.
you didnt post vin or engine option so can say.
but the cam has a sensor. that tells the ECU where #1 cylinder is.
is car a bravada or a jeep grand cherokee. , impossible to tell.
PointsProblem with 1997 Jeep Grand Cherokee Where is the camshaft position sensor on a 1997

P0340 JEEP - Camshaft Position Sensor Circuit engine cylinder Bank 1 Sensor 1

Possible causes- Camshaft Position Sensor harness is open or shorted
- Camshaft Position Sensor circuit poor electrical connection
- Faulty Camshaft Position Sensor
- Faulty starter motor
- Starting system circuit
- Dead (Weak) battery

Sometimes and in some models, low battery voltage or a weak starter can can trigger a Camshaft Position Sensor code.

Read more: http://engine-codes.com/p0340_jeep.html#ixzz25iQflrEb

First check for spark at any of the sparkplugs.

Answer

pic REMOVAL - 4.7L
The Camshaft Position Sensor (CMP) on the 4.7L V–8 engine is bolted to the front/top of the right cylinder head (CMP Location—4.7L Engine).

It is easier to remove/install sensor from under vehicle.

Raise and support vehicle.
Disconnect electrical connector at CMP sensor (CMP Location—4.7L Engine).
Remove sensor mounting bolt (CMP Location—4.7L Engine).
Carefully twist sensor from cylinder head.
Check condition of sensor o-ring.
See picture for sensor location.

p1391= crankshaft / camshaft position sensor intermitant signal, check, wiring, connections & sensors
p1398= engine control system missfire detection limit reached probable causes, wiring,poor connections,engine mechanical fault,ignition/fuel system fault (causing misfire) or camshaft/ crank shaft position sensor

it is inside the distibutor.

i replaced the crank position sensor and woks ok.

The camshaft position sensor is located inside the distributor. It is a hall effect swich, simply remove the distributor cap and the rotor and you can lift it out, unplug and replace.
Have fun but beware a bad crankshaft position sensor can cause a false cam sensor code to be set sometimes.
Good luck.

go to autozones website they have free diagrams