Light staying on even when handbrake is of also

is there a adjustment screw under the boot of the hand brake lever

Assume you know the fluid is full?

You are low on brake fluid, the handbrake is engaged, or the switch on the handbrake needs to be looked at. If it is the ABS light, there is a problem with the ABS system. The brakes will still work fine, you'll just have regular brakes with no ABS.

-Check fuse and relay.


mai

run fault codes for faults in the abs system. check fluid level in the master cyl reservoir. The stability control also use the same wheel sensors as the abs so check the wiring at the wheels.

you should only need one sensor replaced they are usually buil into the wheel bearing. hope this helps

Have you checked the brake fluid level?

They all work the same. Call it parking-brake, hand-brake or foot-brake, it is the same.

Use your hand, or foot to apply the foot-brake, whatever is convenient for you is ok.

If the fluid is full , it sounds like the trans pump is loosing prime. If it is there will be a code set. The code will not always turn on the light. Go have the codes checked. If it does have a loss of prime code in the trans computor and the fluid is full then you will need the trans pump replaced

ABS diagnostics requires a scan tool (Chrysler DRB II, DRB III or aftermarket equivalent). the plug is located near the brake pedal. this is the only alternative to get the ABS light off.