There is not an fuel pump reset button. There is however an Automatic Shutdown Relay that acts as a fuel pump shutdown. On the 1998 Model: It should be located in the Junction Box located under the leftside of the dashboard There should be a cover over the top of the Junction Box. On the backside of that cover is the identification and location of the Relays and Fuses. If there is no cover, your Owner's Manual should have a schematic identifying the location, position, and type of Relay and Fuses. There should be additional Fuses involving the Fuel Pump. Make sure you not only check the Relay and Fuses to see if they are good, also check with a Voltmeter to check for voltage, with the Key in the "ON" (not start) Position; it should read approximately 12v,
With approx 12v present at the Relay and Fuses, one quick way to determine if there is Voltage to the Fuel Pump:
1) With a Partner behind the wheel. Take the Gas Cap off and place your ear up close to the opening of the Gas Filler Tube. Have your Partner turn the Key to the "ON" (not Start) Position. You should be listening for a humming sound (for 2-3 seconds)meaning the Fuel Pump is getting power (volts).
2) If there is no "humming" or you are not sure, get underneath the Van next to the Gas Tank and have your Partner do it again. Listen for a humming.
3) If there is definitely no humming present with good fuses, relays and voltage, then most likely the Fuel Pump is bad.
4) However, a lot of Fuel Pumps have been replaced only to find out the Pump was good, but the electrical wiring harness was bad and the real culprit.
5) You will have to slightly lower the Fuel Tank to gain access to this electrical connection.
6) After you disconnect the electrical connection, using the Voltmeter check for approximately 12v coming from the Wiring Harness/Connector.
7) Inspect the Wiring Harness/Cnnections for any signs of burns, melting, or shorting. Repair this wiring harness before deciding to replace the fuel pump needlessly.
8) After repairing the Wiring Harness/Connection: Replug it back in and recheck the Fuel Pump one last time.
9) If still no "humming" the Fuel Pump needs to be replaced.
If there is humming from the Fuel Pump, then there are four possible problems.
a) Fuel Filter (when was the last time it was replaced?) It could be clogged, prohobiting fuel flow.
b) Fuel Regulator. Located on the Fuel Rail where the Fuel Injectors are. If there is a presence of Gas in the Vacuum line (the only rubber line on the Fuel Regulator) attached to the Regulator, then the Diaphram of the Fuel Regulator is broke and Gas is not reaching the Fuel Injectors. Instead it is being dumped into the Intake. Replace the Regulator.
c) Fuel Injector Circuitry problem. Using an Auto Stethoscope: Place the Stethoscope end in each individual Fuel Injector. Have your Partner attempt to start the Van. If there is no evident and rythmic "clicking" (fuel injector's gate opening and closing) then the Fuel Injector is faulty or the electrical connection is faulty. To check to find out which is faulty, switch Fuel Injectors (one clicking with one not clicking) and recheck for the clicking.
d) Clogged Fuel Injectors. With the Fuel Rail (with the Fuel Injectors) removed out of the engine. Place clear Plastic tubing over the nozzle ends of all exposed Injectors. With a Partner Starting the Engine, look for
(1) Fuel Flow (presence).
(2) Fuel Spray (pressure).
Let me know if this helped, or if you have any additional information or questions. Feel free to contact me at FixYa.com!
SOURCE: 96' Ford E150 fuel pump reset switch
mine is on the passenger side in front of the front door under the dash with a small hole for acess
SOURCE: Motor turns but acts like it is not getting gas
Yes there is a fuel pump reset switch. This switch is designed to shut off fuel flow during an accident. Usually it is located on the inside panel of the dash on the passenger side right by the floor.
SOURCE: Van starts but no fuel is going through fuel pump
hi no it does not have a reset button first check if the fuel pump is activating when you try to start if not check fuses and relay you will find them under the hood in the fuse box and if the pump is activating check for fuel pressure and check for pulse in the injectors good luck
SOURCE: My van wont start, it turns over but acts like it
did you check the spark if occur when cranking engine, if it have spark, direct fuel pump by shorting 30 and 87 pin off fuel pump relay and check if theres fuel go to fuel injectors, check for pressure, if no fuel, connect voltage directly to fuel pump assembly, if fuel turn s, check circuit, if no fuel goes, check the tank for empty fuel, if you have fuel change the fuel pump including fuel filter
SOURCE: my 2004 Chevy Cavalier became
Inertia Fuel Shut Off Switch --- is only on Ford Products
Turning over & Cranking is the same thing
Starting or Running is as you know it
So tell us in more detail
You can not guess at wether you have fuel pressure
or a bad pump
The fuel pump shut-off switch is
located in the driver's foot well,
behind the kick panel. The reset
button for the fuel pump shut-off
switch is accessible through an
opening in the kick panel.
Use the following procedure to reset the fuel pump shut-off switch.
1. Turn the ignition to the OFF position.
2. Check the fuel system for leaks.
3. If no fuel leak is apparent, reset the fuel pump shut-off switch by
pushing in on the reset button.
4. Turn the ignition to the RUN position. Pause for a few seconds and
return the key to the OFF position.
5. Make a further check for leaks in the fuel system.
1,290 views
Usually answered in minutes!
×