At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Go into your settings on the radio and change it to RKE. The alarm will beep when you unlock the doors via your keys but stop once you turn the ignition on, the alarm will not arm unless you lock your doors either.
It's not expensive to program fobs... my dealer will do a reasonable amount (I had 4 of them) for $40 and he states that it would be the same cost for just 1 fob programming
key in ignition 2 number 2 then press the fob. till doors lock. 2 to 3 times then unlock with fob. turn back key lock car. then un lock. then do the same with the other fob.
Often times when you replace the battery in a remote fob you have to sync it to the car by locking and unlocking the drivers door with the key. Check your owners manual.
Gm and Chevy fob can be programmed at home. I have done it my self for a 01 chevy a 03 sunfire. The steps on Step 1 of 5 Get in your Pontiac G6 and make sure all the doors and the trunk are closed.
Step 2 of 5 Put your key in the ignition and hold the "Lock" button on the driver's car door.
Step 3 of 5 Turn the G6 key in your ignition from "On" to "Off" while holding the "Lock" button, and do two more cycles of "On" and "Off" in quick succession.
Step 4 of 5 Release the "Lock" switch on your door and press and hold the "Lock" button on your keyless remote for 10 to 15 seconds.
Step 5 of 5 Remove the key from the ignition of your G6, and test the programming.
Or
Or
Step 1 of 9 Enter your vehicle and close all of the doors behind you besides the driver's door. Be sure to have your keyless remote and ignition key in hand.
Step 2 of 9 Insert and remove the key from the ignition twice in a row and then close and open the door twice in a row.
Step 3 of 9 Insert and remove the key from the ignition again and close and open the driver's door two more times.
Step 4 of 9 Insert the key into the ignition and close the driver's door.
Step 5 of 9 Cycle the key in the ignition "On" and then "Off" and then remove the key from the ignition.
Step 6 of 9 Wait for the locks to cycle to indicate the beginning of the programming sequence.
Step 7 of 9 Press and hold the unlock and lock buttons on your remote for two seconds and then release.
Step 8 of 9 Press and hold just the lock button on the remote for three seconds and wait for the locks to cycle to indicate successful programming.
Step 9 of 9 Repeat steps seven and eight to program any additional remotes and open the driver's door to end the programming sequence once you are finished. Hope this helps
There is no onboard programming procedure for this vehicle. This vehicle requires special equipment be connected to the vehicle to program the keyless remote. SEE THE DEALER.
×