Question about 2002 Audi TT

1 Answer

Audi TT headlight

I have an Audi TT 1998 coupe. Standard headlight configuration. (three lights, fog light, side light and full beam in the centre and the headlight in the third) The headlight bulb has burnt and cannot be removed completely from the power supply fitment. Audi tell me they do not sell this particular bulb fitment and a new headlight is needed!!!!!!

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

I got a genuine one off eBay for a fraction of the cost.
Mike

Posted on Nov 08, 2018

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 25 Answers

SOURCE: my 2003 audi says safe.

if it is the radio saying safe, it requires the radio code to be entered

Posted on Feb 18, 2009

  • 22 Answers

SOURCE: Audi TT 08 Roof wont close

Yes if you go into the trunk you will find a small passage to get to the pump there will be a little T- shaped knob on top turn this untill it stops and you will be able to lift the top to close it.

Posted on Sep 07, 2009

  • 54 Answers

SOURCE: I have an audi TT Coupe, how can i reset the radio

Try disconnecting batt+ for 10 or so minutes and re connect battery but you will have to enter the security code if you enter it wrong it will lock. If you dont have the code you need to call service dept. with v.i.n.#

Hope this gets you tuned in!

Posted on Oct 23, 2009

  • 1986 Answers

SOURCE: Can't adjust the height of the headlights

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

Posted on Nov 04, 2009

JettaRed
  • 7 Answers

SOURCE: Audi TT HID bulb needs replacing

You can change the bulb easily yourself in about five minutes, especially on the passenger side. You may want to disconnect the battery, though I don't know if that is necessary. You may also want to handle the bulbs wearing latex or nitrile gloves so as to not get your skin oil on the glass.

1. Remove the decorative cover that conceals the Coolant reservior. There is a single philips screw near the firewall that holds the cover down.

2. Find the back of the headlight and pull the metal wire clip that holds the back of the headlight cover toward the engine. Remove the cover.

3. Look inside and find the back of the HID bulb--it will be toward the outside fender. Twist the connector until it separates.

4. There is a retainer ring that holds the bulb in. Again, twist that until it comes loose. The bulb should come right out.

5, Put the new bulb in, noticing the notch is on top. Also, attach the retainer ring. It is marked "Top" to help orient it. Reattach the connector with a twist.

6. Make sure everything is firmly in place. Reconnect your battery and test the lights. Finish putting anything else back on.

Good luck.

Posted on Nov 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

In a 2001 Audi A4 with a 2.8L engine, how to fix no power to radio, climate control, and fog lights


Ck the fuses here is the info if you already haven't.
1-Headlight washer jets
2-Turn signal flasher
3-Headlight washer, glove box light, engine bay light, instrument cluster
4-License plate lights
5-Instrument cluster, heated seats, auto trans display, outside air temp
6-Central locking system
7-ABS
8-empty
9-heated mirrors
10-empty
11-cruise control(auto trans)
12-on board diagnostic system
13-brake lights
14-interior lights
15-power windows, climate control
16-ABS, anti-slip(?)
17-heated door locks
18-right high beam
19-left high beam
20-right low beam
21-left low beam
22-tail and side marker (right)
23-tail and side marker (left)
24-wipers and washer jets
25-blower for heating/climate control
26-rear window defogger
27-empty
28-fuel pump
29-engine timing
30-sunroof
31-tail lights, cruise control, auto trans
32-engine timing
33-cig lighter
34-engine timing
35-trailer receptacle(?)
36-fog lights
37-radio
38-trunk light, central locking system
39-flashers
40-horn
41-empty
42-empty
43-heated seats

Ok there's the numbers. To figure out what the hell that means you have to look at the inside of the cover to the fuse box. left side of dash panel. Good luck.

Oct 18, 2017 | Audi Cars & Trucks

1 Answer

Fixing dipped headlight issue on my 2004 audi


Check bulbs and fuse. If they are fine then check the switah. If OK it is wiring.

Dec 01, 2015 | 2004 Audi A4 Avant

2 Answers

How do I get the low beams to run automatically whenever driving instead of flickering?




if you did it yourself and did not use factory lights or ballast then it could be a voltage detection problem. If you did use factory parts then the headlight switch may have failed by coincidence. also check connections at HL plugs and or switch. ???????????

I’m happy to assist further over the phone at https://www.6ya.com/expert/howard_977676954994c5b2

Nov 13, 2014 | 2001 Audi TT

1 Answer

Headlight are dim


check output of the alternator as there may not be enough current produced to keep the battery charged. Check drive belt tension and condition.

May 26, 2013 | Audi Cars & Trucks

1 Answer

High beam indicator comes on with fog lights


Could your Mazda have daytime running lights? If you checked all fuses, did that include the three in the joint box?

There is an auto light-off control module that is central to all functions you describe. It is assumed that you would only turn on the fog lights with headlights on and set for high beam. If you set the headlight switch to LOW, the module closes the headlight relay to turn on the low beams. If you then turn the headlight switch to HIGH, the module turns on the high beams and allows you to turn on the FOG LIGHT switch, closing the fog light relay and turning on the fog lights. Since this sequence is not working, I suggest checking both high beam lamps as both could be burned out. Other possibilities are a defective headlight switch or the module

Oct 01, 2012 | 2005 Mazda 6

2 Answers

Fuel Pump Fuse Number for a 1998 audi a4 2.8 quattro


Fuses: Fuse arrangement in fuse panel, behind instrument cluster, left
Fuse Arrangement In Fuse Panel 62624464

1 - Heated washer jets 5A 2 - Turn signals 10A 3 - Headlight washer (relay), illumination for glove
compartment, climate control, Automatic Transmission, instrument cluster 5A 4 - License plate light 5A 5 - Instrument cluster, seat heating, test connection
for cruise control, bulb monitor for auto-check display, Automatic Transmission display, switch
lighting, mirror switches and actuators, airbag
warning light, outside temperature indicator,
climate control 10A 6 - Central locking system 5A 7 - Anti-lock brake system (ABS) 10A 8 - Vacant 9 - Mirror heating 10A 10 - Vacant 11 - Cruise control (Automatic Transmission) 5A 12 - On board diagnostic system 10A 13 - Brake lights 10A 14 - Interior lights, reading lights, anti-theft alarm system, vanity mirror 10A 15 - Instrument cluster, power windows, climate control, automatic transmission 10A 16 - Anti-lock brake system (ABS), Anti-Slip Regulation (ASR) 5A 17 - Heated door locks 10A 18 - High-beam, right 10A 19 - High-beam, left 10A 20 - Low-beam, right 15A 21 - Low-beam, left 15A 22 - Side marker and tail light, right 5A 23 - Side marker and tail light, left 5A 24 - Wiper and washer system 25A 25 - Blower for heating, climate control 30A 26 - Rear window defogger, mirror heating 30A 27 - Rear window wiper 15A 28 - Fuel Pump 15A 29 - Engine timing 30A 30 - Sun roof 20A 31 - Tail lights, cruise control, automatic transmission 15A 32 - Engine timing 20A 33 - Cigarette lighter 15A 34 - Engine timing 15A 35 - Trailer recptacle 30A 36 - Fog lights 15A 37 - Radio 20A 38 - Luggage compartment light, central locking system 15A 39 - Emergency flasher system 15A 40 - Horn 25A 41 - Anti-lock brake system (ABS) 25A 42 - Vacant 43 - Vacant

Apr 05, 2010 | 1998 Audi A4

1 Answer

1998 Ford Escort dashboard warning lights and gauges not working.


Sounds like possibly the ignition switch is going out. Try jiggling the key in the ignition in the on position and see if your lights come back on.

Feb 15, 2010 | 1998 Ford Escort

2 Answers

Can't adjust the height of the headlights


The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

Sep 13, 2009 | 2004 Audi TT

1 Answer

What size bulb is an audi s4 headlight and fog light?


SYLVANIA H7 SILVERSTAR HIGH PERFORMANCE HALOGEN HEADLIGHT BULB -- 55 Watts, Single C-8 filament for use as either high beam or low beam; 100 percent legal halogen headlight bulbs; Features the whitest and brightest light colour similar to daylight for safer night driving; Meets all US FMVSS 108 and Canadian CMVSS 108 requirements. Fits Driver or Passenger Side Driver or Passenger Side Fits the following vehicle/s
2004 Audi S4 Base 8 Cyl 4.2L 2004: Base; 8 Cyl 4.2L RAMPAGE FOG LIGHT, BLACK METAL HOUSING, With round clear lens; Includes 100-Watt H3 halogen bulb, one lamp and a single bolt mounting system; Provides better illumination Fog Light

  • Fits the following vehicle/s: 2004 Audi S4 Base 8 Cyl 4.2L 2004: Base; 8 Cyl 4.2L;

Jun 24, 2009 | 2004 Audi S4

Not finding what you are looking for?
2002 Audi TT Logo

Related Topics:

137 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Marvin
Marvin

Level 3 Expert

84540 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...