I am assuming you are asking about the Blower Fan and not the Radiator Fan?
The Blower Fan is located below the Passenger side Dash. It is inside the black Duct work.
May I ask what the problem is?
Is the Blower working or only working on High? If only on High then the Blower Motor is fine and the Blower Motor Resistor that controls the Low to High speeds is bad. This is located behind the Glove Box in the Dash and on the firewall. Remove the Glove Box to access. It is approximately 3 1/2 inches by 1 1/2 inches and has 3 to 4 wires going into it.
There is also a Front Blower Motor Relay located in the Relays and Fuses.
Before replacing the Blower Motor, get back with me (for free) and let me know. This may save you alot of money in the long run, saving you from purchasing parts you may not need!
Let me know if this helped, and let me know what the problems (symptoms/signs) are.
Contact me in the Comment Section of your Posted problem.
Testimonial: "thank you the blower is not working at all."
TIP: When you disconnect the Resistor to Motor connection: Check for voltage(s) at that connection. Do this with the Battery reconnected, and utilize all speeds. IF there is no voltage, then unplug the Resistor from the electrical connection and check for voltage prior to the Resistor. If there is voltage now, then the Resistor is bad. To further check if the Motor is good: with voltage prior to the Resistor. Use a jumper wire from the positive connection prior to the Resistor to the positive of the Motor. If the Motor comes on then the Motor is good.
Hope this helped you more.
Will wait for your husband to return home and reply. Hope to save you from purchasing unnecessary parts. I do this "free" all the time.
Sincerely;
Pat
×
SOURCE: starter for dodge caravan 2000
DISCONNECT THE BATTERY, JACK UP AND SUPPORT YOUR CARAVAN. LYING ON YOUR BACK LOCATE THE STARTER WHICH IS ATTACHED TO THE ENGINE THROUGH THE BELL HOUSING .THERE ARE TWO 15 MILIMETER BOLTS THAT HOLDS THE STARTER ON . AFTER BREAKING THE BOLTS A 15MM WRENCH WOULD BE USEFUL.
SOURCE: 2000 Dodge Caravan air conditioner problems
heating and cooling fans are generally one and the same. changing freon doesn't always fix the problem... did you have the system pressure checked for leaks first.
Second determine if the vents are opening properly (switching from heat to cooling) basically when you change to cool it closes air access to the heater core.
Robert
SOURCE: replace broken fuel door 2000 dodge caravan
If you're on the smallish side and pretty limber, you might avoid removing the rear wheel. If not, you will likely need to remove the rear wheel and put the van on jack stands securely. I would remove the underside splash shield and gain access from underneath. It looks like you will need to unscrew the plastic insert that surrounds the filler neck inside the area that is exposed when you open the fuel door. Make sure you get the vent hooked up correctly when you are done.
SOURCE: 2000 Dodge Grand Caravan need to know where relay
the cooling fan relay is not in the fuse box.
it is a solid state relay bolted to the radiator core support just behind the bumper
SOURCE: Radiator Fan Relay for 97 dodge caravan
it is mounted under the radiator towards the drivers side,it is flat and held to the frame with 2 small bolts and has a flat wire connector,it doesnt look like a normal relay,its black with a silver plate on the front of it,hope this helps
Testimonial: "awesome found it immediately........thank you"
245 views
Usually answered in minutes!
the blower fan is not working at all
i will let you know as soon as we check the van it's not here my husband has it at work thanks!!!
×