I can not seem to find my fuse diagram to show me

Try 2009 dodge avenger fuse diagram Google Search

Gotta tell you, this question had me a little confused. Below are 2 wiring diagrams for you. One is for the cruise control circuit and the other is for the air conditioning circuit. The reason I gave you those is because it seems according to the wiring diagram in the cruise control that the fuse for the cruise control goes to the HVAC (air conditioning). According to the wiring diagram for the A/C yes that fuse also controls the ignition power for the A/C controller. In any case the fuse that would cover the cruise control is the number 30 fuse in the fuse panel located under the hood of the vehicle. Below is a picture of the location of the fuse panel and also fuse layout diagrams for the 6 cylinder and 8 cylinder engine vehicles as they have different layouts depending on the engine size. I hope this helps you and good luck.

Sounds definitly like a fuse or a relay. If you have owners Manuel it will point out which fuse/ relay to replace. Remember, if a fuse blows there's a reason for it that needs to be remedied

To find the Fuse for your Lighter Take off the Fuse Box Cover ,On the back side of the Cover there will be a Diagram,Showing You Which Fuse goes where and Also Shows you The Proper Amperage,If you Have the User Manual it will also have a Diagram of the Positions of Where Each Fuse Goes.Cigerette Lighter on Some Vehicles Is Marked in Fuse Block as Accesories or Could be a Seperate Fuse for Cigerett Lighter. Hope this Gets your Lighter Working Again. From the WYOCWBOY Vote and that will tell me i solced your Problem.

There will most likely be more that one component that goes bad w/ these systems. Here is a wiring diagram showing all of the components...

Likely you are looking for a 30 amp circuit breaker...(Looks like a small rectangular metal fuse) But...if the power door locks work, i don't think that it's bad (serves locks & windows) My diagrams show a bunch of diodes and resistors inside the master (drivers) door switch, but I've had a few apart and never saw any. (embedded?) Personally I don't see anything that shows me reliability built into the switch...It's a really "iffy" design (one in my niece's Jeep only works when the sun shines on the drivers door) There is also a control module associated with the windows but I've never needed to replace one and the manuals never tell you where they are!
Check power at the switch and check harness where it goes through the rubber boot between the door and body. at least 80% of problems I've seen are either the switch or that wiring. Wires can be spliced and you can get a decent used switch at most scrap yards.
Good luck...glad they aren't stuck down!!!

hi I am jeff
your question you need to change your fuses and you need to know where each fuse goes

http://www.carfusebox.com/suzuki-forenza-2005-under-dash-fuse-boxblock-circuit-breaker-diagram/

Fuse No 64 on back of fuse box inside cabin behind glove compartment undo two bolt and turn fuse board around pull the wires gently apart to see fuse 20 amp