2002 Honda Accord SE alarm won't turn off. We've had this car to Honda, and never can seem to get a solution. It will work correctly or not, we never know, at least it won't be going off. But then one day stick the key in the door and it will start going off. How do you disable it, blow it up or what! HELP!

SOURCE: need to replace radiator in 1997 honda accord se. what are the steps?

First drain radiator by opening drain valve,"located on bottom corner usualy the right,but not always." If you open the overflow or remove cap this will happen much faster.For safety sake disconnect ground wire from battery,the radiator is locked down by top cover that attaches to body with generaly 4 bolts, upper and lower hoses have to be disconnected and if it is automatic the transmission cooling lines are connected in stacked fashion,"one above the other."The cooling fan has to be unplugged and it should be removable at this point,"when unplugging fan be carefull with connector so it doesn't break.reverse steps to replace making sure the bolts go in the right place and it all fits properly.the thermostat,"located behind the kneck of upper hose," should be replaced after connecting lower hose because in order to fill the block up and prevent damaging thermostat the block shoud be filled with coolant before attaching upper hose.

SOURCE: 1997 Honda Civic: Battery died and the Alarm won't disable

i would try to charge the battery and turn the alarm off with the remote

ZJ Limited

• 17989 Answers
• Posted on Jul 16, 2010

SOURCE: 1997 honda accord se need to change vss,where

For 1997 Honda Accord 2.2L MFI 4cyl the Vehicle Speed Sensor - Location is located mounted on transmission.

OPERATION
The Vehicle Speed Sensor (VSS) is a magnetic pick-up sensor that sends a signal to the Powertrain Control Module (PCM) and the speedometer. The sensor measures the rotation of the output shaft on the transaxle and sends an AC voltage signal to the PCM that determines the corresponding vehicle speed.



TESTING

1. Disconnect the negative battery cable.
2. Disengage the wiring harness connector from the VSS.
3. Using a Digital Volt-Ohmmeter (DVOM), measure the resistance (ohmmeter function) between the sensor terminals. If the resistance is 190-250 ohms, the sensor is okay.

1. Disconnect the negative battery cable.
2. Disconnect the three terminal connector from the vehicle speed sensor (VSS).
3. Remove the fasteners that secure the VSS to the transaxle housing assembly.
4. Remove the VSS.

1. Install the VSS.
2. Install the mounting bolts.
3. Connect the three terminal connector to the sensor.
4. Connect the negative battery cable.

SOURCE: brake lamp light on a 2002 Honda Accord SE

I assume you mean the one on the dash. This is an indicator that there is a problem in your braking system. Make sure it's not low on Brake fluid and have the brake system checked or check it yourself. If your going to check it yourself I recommend the Haynes repair manual on your vehicle as a reference.

SOURCE: Gear shift stuck in park -- 2002 Honda Accord SE

Take it to the dealer to fix it for a permanent solution, but there is a quick fix when in a bind...

There is a little key space on the left side of Park, take a screwdriver and open that and then take the screwdriver and touch the pad that is about an inch down in that hole, while touching it, you can put the car into any gear.

It is your celluloid that is sticky, which sometimes happens in hot/muggy weather. You may need that replaced.