The Air bag light flashes for a few seconds, then stays on steady. any pointers?

Sergio, try giving your horn a bump with your fist, does the light go off? A few of us have had that problem, ended up being the clockspring.

electrical issues since replacing alternator & battery - Mazda 6 ...

forum.mazda6club.com > Mazda6 (Atenza) > Newbie Section

Dec 24, 2010 - Exclamation Battery Light after Replacing with New Alternator ... TheBattery Light stays on after I start the vehicle. It comes up after ~2-3 secs of ...

Battery light flashing, air bag light on, after alternator pulley ...

https://forums.tdiclub.com/showthread.php?t=343786

Feb 11, 2012 - Battery light flashing, air bag light on, after alternator pulley changeTDI 101. ... Almost a week later I am driving home and the battery light flashes on, then off, .... Seat belt light stays on, no air bag light. cjharris02892, TDI 101 ...

Battery Light Due to Damaged Alternator Wire Harness ...

repairpal.com > Problems > Ford > Crown Victoria

Battery Light Due to Damaged Alternator Connector on Ford Crown Victoria ... how can i turn off the airbag light on a 1991 crown victoria made by ford ... the battery light onreplace alt and batt light still what else can it be? thaqk. it sat for two weeks when we had snow i used my truck staqrted car light comes on and stays on.

Airbag light = bad battery - Maintenance, Recalls and T

A flashing airbag light can mean one of two things. The first possibility is that your battery is in death row. Have it tested at your local parts store. The second possibility is that there is an actual problem with the airbag system. Below is a list of airbag codes, which will flash on the warning light. For example, the light will flash once, pause and then flash twice == 12.

12=Low Battery Voltage
13= Air Bag Circuit Shorted to Ground
14=Primary Crash Sensor Circuit Shorted to Ground
21=Safing Sensor Not Mounted to Properly
22=Safing Sensor Output Shorted to Battery Voltage
23=Safing Sensor Circuit Input Feed/Return Circuit Open
24=Safing Sensor Output Feed/Return Circuit Open
32=Driver Side Air Bag Circuit High Resistance or Open
33=Passenger Side Air Bag Circuit High Resistance or Open
34=Driver Side Air Bag Circuit Low Resistance or Shorted
35=Passenger Side Air Bag Circuit Low Resistance or Shorted
41=RH Primary Crash Sensor Feed/Return Circuit Open
42=LH Primary Crash Sensor Feed/Return Circuit Open
44=RH Primary Crash Sensor Not Mounted to Vehicle Properly
45=LH Primary Crash Sensor Not Mounted to Vehicle Properly
51=Air Bag Diagnostic Monitor Internal Thermal FuseFuse Blown Due to Intermittent Short to Ground
52=Backup SupplyVoltage Boost Fault
53=Primary Crash Sensor Circuits Resistance to Ground or Air Bag Diagnostic Fault

Hope this helps...

"If you have the airbag light, it will show steady for a few seconds (the manual says 7 secs) after you turn the key from off to on (but not start) and then start to flash. Here is how to reset it:

1. Turn the key from off to on.

2. Watch the airbag light closely. It will stay on for a few secs. and then as soon as it blinks off (the start of the flashing), turn the key off instantly.

3. Count to 5 (1 Mississippi, 2 Mississippi . . . .)

4. Repeat steps 1-3 two more times until you have done the cycle three times.

5. Now turn the key on and watch the light. It will start blinking in a different, slower manner. This is diagnostic mode. You can watch this for a little while, no hurry.

6. Now turn the key off again, Count to 5 like in step 3 again, and turn back on. If the procedure worked, the airbag light will not be flashing.

If it does not work the first time, just repeat the steps again."

srs means secondary restraint system. e.g air bags and things like that. when it stays on for a few seconds its because it is doing a systems check. if the light stays on all the time then there is a problem. hope i helped.

To manually check air bag codes, turn the key On and push the driver's door switch (at the bottom of the B-pillar) 5 times or more within 7 seconds of turning the key ON. Then watch the air bag light flashing codes. The air bag light will come ON for 3 seconds and then give fast flashes if there is a code. Count the fast flashes as the code. So the air bag light on for 3 seconds and then 8 flashes is a code 8 for the passenger air bag circuit. after counting code clear codes and see if they come back

Hello Harvey,

The Air bag warning indicator will FLASH and/or stay on STEADY if the system has detected a fault.. The fault can exist anywhere in the system, sensors, wiring, air bags, module, etc... I recommend you take it to your local Ford, Lincoln, Mercury dealership or a qualified reputable repair shop familiar with late model Ford SRS systems.. For Diagnostic trouble code retrieval and system repair...

Bill Andrade Ford Master Technician/ASE Master Technician

Try this:
5. If “AIR BAG” warning lamp operates as [as I said before], turn ignition switch “OFF” to reset from Diagnosis mode
1. Turn ignition switch “ON”.
2. After “AIR BAG” warning lamp lights for 7 seconds, [i.e. when it stops running solid and starts flashing] turn ignition switch “OFF” within 1 second. [DO NOT SWITCH IT TO LOCK, SWITCH IT TO ACC]
3. Wait more than 3 seconds.
4. Repeat steps 1 to 3 two times. (Perform 3 times in total.)
5. Turn ignition switch “ON”.
SRS is now in Diagnosis mode.
Try it a few times. If you can't get it to work, have someone else try. If you STILL can't get it to work, check your battery voltage. It might be low.
In diagnosis mode, you're going to hope the light flashes slowly. 2 seconds off, 3 seconds on, and repeats. If your light does this, this means that the computer detected a previous error that hasn't been erased. This is good.
to User mode and to erase the memory of the malfunction.
6. Turn ignition switch “ON”. “AIR BAG” warning lamp operates in
User mode. [it should stay on for 7 seconds, then go off, like normal.]

air bag light stays on

First you got to check the conections to the module otherwise contact :http://www.myairbags.com/ or http://www.airbagsystems.com/index.html