Electrical door locks not working and no inside lights

1. Check the door lock mechanism: Ensure that the lock mechanism is functioning properly by checking it manually. If it's not working, it may need to be repaired or replaced.
2. Check the electrical system: Make sure that the wiring and connections are secure and functioning properly. If there is an issue with the electrical system, it may need to be repaired.
3. Check the control module: If the door lock mechanism and electrical system appear to be functioning properly, the issue may be with the central locking control module. It may need to be repaired or replaced.
4. Contact a mechanic: If you are unable to resolve the issue on your own, it's best to take your vehicle to a qualified mechanic. They can diagnose the problem and provide a solution.

Note: The solution will depend on the specific issue, so it's recommended to have a professional diagnose the problem for an accurate and effective repair.

A non electric door, (which?) wont open,lock works ok, handle wont open the door.
What can I do to fix it.
well telling the door to us would help, and options.
so no electric locks,
there are 2 levers. one inside and one outside.
so you pull the door card (inside door covering)
and look at both locks , the inside pull, its it working?
then look at the key lock cylinder. is it connected still
and last are both connected to the latch mechanism.
one can cycle this latch lever inside the door shell.
if that fails the latch is busted.
all this is covered in the FSM ,why not read it.? (under body)
free , too.
http://hondatech.info/downloads/Auto/Manuals/Accord/

check all your fuses in engine compartment and under dashboard engine check light comes on every 3000 miles for oil change reminder

unlock the door, hold the door handle in the open position and with a screwdrive you should be able to slide the latch open

IF DOOR LOCKS LOCK AND UNLOCK.WHILE HAND OPERATING DOOR LOCK SWITCH.YOUR REMOTE KEYLESS BATTERY WEAK.IF DOOR LOCKS DONT WORK BY USING YOUR HANDS TO WORK THE SWITCH.LOOK FOR A BLOWN FUSE OR CIRCUIT BREAKER.

have you tried locking from the passenger side switch? alot of times if a window is left down during the rain, water will run in on drivers side and right down into the power window and lock switch causing it to corrode inside over time.

I'm assuming the locks work fine with the key. If so, it sounds as if the electric lock motor is bad or the unlock wire is broken. You would have to take door panel off and check with a test light to find what the exact problem is.

You have to check the door Modules and locks, as the modules are the part that is responsible for locking and unlocking the doors and the locks are electric parts. So what you need to check while sitting inside the car , when you lock the doors which lock does not lock with the rest , or which one opens first , and that is probably the one you need to check.

Here is step by step pictures:
http://www.bodyshopzone.com/archives/trim/door_panels/Toyota/Camry_2000_front/removal_f4.html