Tyre pressure loss warning indication how do i reset after checking tyre pressure

Follow these simple steps to reset the BMW TPMS without the iDrive system:

1. Check all tyre pressures are set to the manufacturer's recommended settings.
2. Use the indicator stalk to scroll down until you see the tyre symbol and 'RESET'
3. Press the BC button on the end of the indicator stalk.
4. The display with show 'RESETTING'

this is the tyre pressure warning light, indicating that one or more of your tyre pressure's is either to low or to high , so check the tyre pressures and it should go out , owners manual will give the correct pressure's for front and rear

Tyre pressure warning light
Check pressures
When correct,turn ignition on and use lever on top of indicator stalk to scrool untill you see tyre pressure reset
Press end of stalk to reset

Insert key press start button,push scrool on top of indicator stalk,untill you see tyre warning. Then press end of stalk to reset

you may need to reset the tpi for the system to work.
TPI tire pressure indicators.

I believe your tire calls for 32PSI. Try to setting it to 36PSI and starting the car to see if it resets. If it does, you can let the extra air out. Sometimes a difference of 2-3 PSI from the set value won't reset it.

Some vehicles also require being driven at speeds above 40mph for about 15 minutes before the light will reset

hi from uk TPMS tyre pressure managment system ? this indicator may well be a simple tyre pressure under inflated ? for some reason ? slow puncture ? when were tyres last checked for correct pressures ? you should check routenely at least weekly ? not wait for indicator warning ? if you check pressures then try see if light resets ?

if yellow this is most likely your tyre inflation indicator warning.
this means that one or more of your tyres has defated or inflated outside expected limits (do not worry)
1. check your tyre pressures are correct.
2. switch on the engine and let light come on.
3. press and hold the reset button with the same horseshoe icon which is situated near your gear lever in the middle console after several seconds the light should go and and your tyre pressure warning system is reset and ready for any change in prssure. if this does not work consult your nearest certified VW dealer they will be happy to assist.

This will only come on when a tyre has dropped in pressure (not spare). It work on the principle that a tyre with less air has a smaller rolling circumference and therefore a different wheel speed. This is then monitored against other signals from other wheels and determined that a loss in pressure has occured.

If all tyre pressures seem ok, there could be a chance of a small unoticeable leak and would require a bath test. This is when the tyre is dipped in water and bubbles would appear where the puncture is.

Ultimately the system may just need to be reset, or has incorrectly been reset from a tyre change. For this you just press and hold the TPC button (located on the centre console above the gearstick - looks like a flat tyre with an exclamation) turn on the ignition to position 2 and the light will come on re then yellow,go out, come back on yellow. When it comes back on yellow it re-initializing the system. You can let go of the button and after 20 odd seconds the light will go out for the final time, completing the reset.

If the light continues to come on after the reset then you definitely have a puncture somewhere!

Hope this helps!

Using the indicator stalk, navigate to the tyre pressure reset option, press the reset button twice in short succession but hold it in the second time until a tick appears on the display