Hood will not open when you pull release handle inside car 2005 buick lacrosse

Take a pair of pliers, and pull the cable where handle hooked to it. Helps to have some one push down on hood while you pull cable.

You maybe able to access it from underneath and behind your radiator ??

use the key to unlock the door and pull hood handle

Usually this takes two people. One works the release handle as the other press down on hood and pulls up on hood. Once open lube latch with a good penetrating oil

On your driver side, lower left side, down to where you would place your left feet, there is a handle that has a hood logo on it, pull this handle back, and your hood should be released, then go to your hood, toward the center of the hood, slide your hands under the hood and lift it up a little bit, (it won't open yet) then there is a release lever that needs to be pull, (be easier if you take a look) with your fingers, and once you pull on it, should release your hood, and then open the hood.

Open the hood, look at the headlight. Most have a plastic clip that you can pull up. This will unlock the light socket. Then reach in behind the grill and turn the light socket counter clockwise and pull it out. Then unclip and disconnect the light bulb from the socket. Reverse procedure to install the new light bulb.

The procedure to replace head light assembly on buick lacrosse is as follows:--- 1)To remove and replace the headlight assembly you will need to remove 1 retaining bolt on the top of the headlamp assembly and 2 sliding retainers at the rear. 2) The carefully Pull up the retainers and that will release the headlight assembly and allow you to pull it out the front. 3) When installing the new headlight assembly make sure you have it lined up correctly before trying to install the retainers, don't force them it may get cracked . 4) Both the cover and the bulb are removed by a standard twist to the counterclockwise and replaced by a twist to the clockwise. 5) Now to the dim light. You have to release the entire light assembly before you can remove the screw-on cover to reach the light. 6) On the rear edge of the light unit closest to the engine is a white locking tab. Pull that tab up just to the point where it releases…pull too far and it locks again. 7) Next, locate the other locking bracket which is a metal bracket in the center-rear of the light assembly. This bracket is held down by a screw. 8) Remove the screw with a 10mm wrench. Lift the bracket just like you did the white bracket. You should now be able to pull (or pry) the entire light unit forward a little. Depending on the size of your hands this might be enough. Note:-- The turn signal is part of the headlight assembly on your 2005 Buick LaCross. 9) To replace the headlight bulb you need to remove the front bumper cover. 10)To release the plastic bumper assembly to give you a little more space. This is done by removing two expansion locking pins, one that holds the little plastic strip down between the bright and dim lights and one that is located inside a rubber bumper on the engine side of the light unit. 11)To remove these locking pins, pull or pry up the little tab in the center of the pin. Thanks.

if its broken at the handle inside the car use a pair of pliers to pull the silver cable if it is broken outside the car there is a black plastic shield on the underside of the car, remove it and the lack will be visible use a screw driver to release latch

use a wedge to wedge the door open a lital bit on top and use a strait peice of metal that can bend fairly easy to go down inside of the car and hit the unlock button. or call a tow truck company and they will come out to help for $40 or $50

lock rod has probably come off from door lock, try to get inside panel off or have someone with slim jim try and reach the rod to unlock the door