Having trouble with wiring of oxygen sensor

If it is code 13.... It means a problem with the oxygen sensor or circuit

Clutch pressure plate and throw - out bearing needs to be replaced soon.

I have the same problem few days ago and found my solution on Fixya Expert Sources website. Here you will get all the top sources of your problem. All the sources of this site provided by top Fixya Gurus. Have a good look at the sources of the page. Go through the sources to find your solution. Hope it will help.


View Count:7

ignition module is most likely ,but it could be the crank sensor unless you have a distributor as some older opel corsas had the pick up sensor inside the distributor

1997 Geo Metro 1.3 liter L4 VIN "9"




Hope helps. (remember rated and comment this).

Have you checked (or replaced) the O2 sensor. This can cause the engine to run bad at cold temps if the sensor is bad

we found the flasher curcuit had no power to the hot prong. So my friend wired the flashers hot prong into the radios fuse curcuit to get power to it and put a separate 10amp fuse on the new lead.

It's either under the dash by your left knee or down on the drivers side kickpanel.

There is probably something shorting the front turn signal wires; the car is supposed to turn the signal light circut on and leave it on if it detects a burned out light bulb. The flashers, however, are supposed to work normally no matter what happens.
Hope this helps!

You have an heated Oxygen sensor. 2 of the wires heat up the sensor and keep it at a certain temperature, it is turned on and off by the computer. The other 2 are use to send a very low voltage reading back to the computer to tell the computer if the engine is running rich or lean. I don't have a diagram to tell you which wire does what but you can get a manual and that should give you the information that you need and tell you how to trouble shoot it to tell if the sensor is bad or not, you may want to look for a wire laying on the exhaust, I have found wires burnt and lay on the metal.